router table fence
les winter
>I'd be interested in knowing what you-all use for router fences.
I just finished up a few kitchen cabinets for my laundry room as a warm up to redoing the entire kitchen. The coping and sticking of the doors on my router table wasn't too much fun. The table top is big and flat, and the router is big Porter Cable. The fence is from hunger.
It's an "L" made of oak which is pretty straight and pretty flat, but it's just no fun to fool with the two clamps to hold it down, two more to hold the bit guard, more to hold feather boards...
I enjoy using good tools.
So I started looking about and I like the Jessem. But it goes against my grain to spend 200 bucks on an extrusion and few brackets. A nice length of 4x4-inch 3/8" thick aluminum angle costs around $80. A little saw work and I'd think I would be ok.
Any creative input would be appreciated.
thanks
les




