Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

What did I do wrong

Posts

What did I do wrong

#1

What did I do wrong

Terry Alexander

>I have 16' of cabinet in my workshop. It is not air conditioned or heated. I have 7 cabinet doors that measure (approx) 21" x 24".

I used plain jane pine 1 x 2's for the frame and the inset is pegboard. I put poly on the pine. Put them in my Bessey's and all seemed fine. Now, approx 3 months later these doors are so warped that I don't think I have any choice but to cut away the frame (salvaging the pegboard) and start over.

Before I do that, is there any cure for the warping? (1 door sticks out almost 3 inches!).

And....if they are not salvagable, what should I do different the next time?

As always....TIA

Terry Alexander

Re: What did I do wrong

#2

Lee Grindinger

Plain Jane did you wrong

Lee Grindinger

>I'm guessing by "Plain Jane" you mean construction lumberyard 1X2s. Construction lumberyard lumber (Home Depot and the like, too)is not dried to cabinet and furniture standards, generally 16% to 18%.

Next time buy your pine from a lumberyard specializing in cabinet/furniture wood and specifically ask if it was dried and conditioned to around 6% moisture content.

Lee

Re: What did I do wrong

#3

Where did you get your wood?

Lee Schierer - McKean, PA

>Much of hte pine at teh local lumber places like Lowes, Home Depot, 84 Lumber etc are shipped by rail on open racks with just a sheet of plastic covering them and tend to have a high moisture content. You generally need to let them dry out before making anything other than house framing with them. It can take a month or more inside a store for the wood to dry out.

I would suggest investing in a good moisture meter and not making anything from lumber with a high MC.

Lee

Re: What did I do wrong

#4

Re: What did I do wrong

Thomas Skaggs, Foothills of Mount Level

>A lot of common pine that you buy these days, especially from Borgs can be notoriously high in moisture content. Once that wood starts drying it can warp and twist like crazy.

Not much to do but replace. A ply or MDF is more stable. In a non-climate controlled shop you'll want to seal or paint the surfaces and edges.

Tom

Re: What did I do wrong

#5

Re: What did I do wrong

John E

>I agree with Lee - pine lumber from the big box stores isn't useful for anything but rough construction, and barely for that. I once had the bright idea to build a table top out of 2x6's, and by the time it finished warping, I could have cut slats for a rocking horse out of them. Fortunately, it did so before I had much time invested in it's construction, so I just scrapped the project. If you're just building shop cabinets, I cheap route would be MDF.

John