Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Bubbles in poly

Posts

Bubbles in poly

#1

Bubbles in poly

ken raddon

>Okay here's my first post ever, be gentle.

I wiped on some polyurethayne onto a alder veneered plywood. The first two coats looked great. But I tried a third and cant get it to go on without looking blotchy (read shinier in some spots) or having bubbles. What am I doing wrong. I used a pad, a foam brush, and a paint brush. Please help.

Ken Raddon.

Re: Bubbles in poly

#2

Re: Bubbles in poly

JW

>Ken, Wipe on poly is meant to be wiped on, not applied with foam bursh and or other brushes. It's a th8innned version of regular poly and will tend to foam/bubble more easlily than regular full trength poly.

Try wiping it on with a folded rag or a folded cheesecloth with some regular cotton cloth inside to serve as a small "reservoir".

If you're using regular full strength poly, brush it on lile usual and skim it over with your brush in the final stroke. That should remove most or all bubbles.

Also stir the poly before using. Don't shake the bottle. That will foam the poly and you will get more bubbles on your wood.

Re: Bubbles in poly

#3

Re: Bubbles in poly

Dave Bair, Eaton Rapids, MI

>If you are getting different levels of gloss, probably the wood surface is not uniform. Usually, some of the grain is not filled by finish and some is. Between coats of poly, try a light sanding with 320 or 400 grit paper. That will create a substrate with a more uniform level of gloss for the next coat. Do not use mineral spirits to clean up the poly sanding dust; it sometimes seems to react with the remaining poly and creates an real mess.

If you get bubbles (or even dust nubs), try tipping them off with a dry brush or a folded square of cheesecloth. You will end up with a thinner coat of poly, but it will dry faster. Bubbles generally result from your brushing technique (I cannot apply a finish coat of poly using any type of brush, so I have no hints. I just see so many articles about brushing it on that I assume my technique is at fault) or from air being released from the open grain of the wood for the initial coat.