Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Burn marks on raaised panel

Posts

Burn marks on raaised panel

#1

Burn marks on raaised panel

Doug Reynolds in Seattle

>Ended up with some burn marks while milling a raised panel out of quarter sawn Jatoba. Since the worse portion is on the end grain, how can I remove the burn marks while maintaining the ogee profile and, not leaving scratch marks?

Re: Burn marks on raaised panel

#2

Ellis Walentine

One idea

Ellis Walentine

>Doug, I have had luck with contoured sanding blocks made from styrofoam insulation. Take a block of blue board or other solid foam and file or otherwise approximate the shape of your ogee on one edge of the foam block. Put some sandpaper on a sample of your ogee and use it to sand the reverse contour on the foam. Then put the sandpaper on the foam and use it to sand the ogee.

Ellis

Re: Burn marks on raaised panel

#3

sanding can be slow

Bill Tindall, E.TN

>I suspect you will discover that sanding away the burns will be slow. On the end grain I would start with 100 grit. Scratch marks are removed by progressing to finer grits until the scratches are insignificant- 100, 120maybe, 180 and 220( if needed).

If possible it would be best to remove them by making another very light cut on the panel. Light finish cuts won't burn unless you stall the cut in one spot.

I trust you are using a sharp quality bit. Cheap, and therefore poorly ground, bits are more prone to burning. End grain is especially challenging for cheap bits.

Re: Burn marks on raaised panel

#4

Two Suggestions

Mark Mandell - Gone Round In Jersey

>If you go the sanding route (BTDT), try to raise the end grain with a bit of water and allow to dry before you start. This will help to break up the scorched/glazed fibers.

If you go the light cut route, clean your cutter first to remove any lignin and/or sugar build up. Oven cleaner or paint thinner and a stiff brush does nicely and then wipe clean. This will reduce friction in the cut and prevent tranferring old char back to the wood surface. Also be sure to keep your feed rate up to reduce heating the cut surface.

mm

Re: Burn marks on raaised panel

#5

Re: Burn marks on raaised panel

Wayne Carson "TX"

>I was watching Charles Neil on his site and he put some streach wrap on the molding and mixed up some Bondo and put it over the molding and after it dried removed the streach wrap and put some PSA paper on the bondo and sanded the profile. Looks like it would work very well.

Re: Burn marks on raaised panel

#6

Ellis Walentine

Great tip!

Ellis Walentine

>

Re: Burn marks on raaised panel

#7

JL

Re: Burn marks on raaised panel

JL

>How about contoured sanding pads or non-woven abrasive pads. I like the non-woven pads.

Re: Burn marks on raaised panel

#8

Re: Burn marks on raaised panel

mdclor

>I have seen this method previously and it was suggested to insert a wooden handle into the Bondo to make it even easier to sand with. I haven't tried it myself, but it seems like it would work.

Good luck.