Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

cope and stick question

Posts

cope and stick question

#1

cope and stick question

les winter

>I read somewhere that it is common to run all the sticking through a shaper or router table and make the coping cuts later as needed. Well, I tried this using maple for the sitcking for 4 doors for laundry room wall cabinets I am building. I ran a scoring cut, 1/16" deep and then a full depth cut with little chipout.

When I went to make the cope cuts, I realized that the backing board didn't match the profile and allowed significant blowout as the cutter reached the trailing edge of the board. Fortunately, this is a Shaker profile, and I was able to mill a board with the reverse pattern and save the stock.

Is the method I used the normal way this is done?

thanks.

Les

Re: cope and stick question

#2

Re: cope and stick question

Jay St. Peter - SoMD

>Mill a scrap board with the cope profile to use as a backer board. I do no hand cleanup for fitting the joints. When you mill the cope cuts, you will need to flip the backer board between flat and cope depending on which end of the rail you're running through.

- Jay