question for Steve on Taklon and application
Bill Tindall, E.TN
>First an answer to your question. I have only made one yellow foam "brush" and it was quicker to make than the time to soften a real brush with shellac left to dry in it. So there was not much incentive to preserve the foam applicator beyond the need for the project at hand. I think the letting it dry in the foam would not work well. The foam holds times more material than a real brush, or at least the pricey Taklon brush I have. Hence, it would take considerable soaking to revive the foam. But then one could ring it out before storage.
Now for a question of you..... My Taklon brush was a failure, or my technique was a failure. I would like to know what you do different that led to success with a brush.
I bought a $30 brush from an art store. It is about 1 1/2" wide, maybe 2" long by 1/4" thick and called a "flat wash brush".
Failure mode: If the applicator, be it a cloth covered wool ball, foam or brush, runs out of shellac during a pass down the length of a board I can't reload and then restart this pass without a lap mark. My brush holds so little material that it needs reloading every few inches. Hence, it is useless in my hands for something as long as a foot. The only way I have successfully applied shellac is with an applicator that holds gobs of material- cloth covered wool ball, foam or my favorite, spray it.
Can you offer any advice? The more I use shellac the more fond of it I become. I would like to be able to do small pieces without starting up the spray gun.