Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Rubbing Poly finishes

Posts

Rubbing Poly finishes

#1

Rubbing Poly finishes

Ed Beck

>Thanks for the responses on my poly over shellac question, removing the shellac with denatured alcohol would have been a great way to go.

For my follow-up question, I've been reading about rubbing the finish to get a satin or gloss finish to it. I'm using General Finishes Arm-R-Seal Urethane Topcoat Semi-Gloss to finish curly maple.

The book I'm reading The New Wood Finishing Book: Completely Updated and Revised by Michael Dresdner discusses rubbing as the next stage to get a really beautiful finish. In it, he says to wait a month before rubbing for a gloss finish, and a week for a satin finish.

A couple of questions,

1. Would you recommend a satin or a gloss finish for curly maple? I have no idea what each finish would do for the appearance of the wood.

2. Are these cure time sufficient taking into account that I live in the PNW and it's perpetually wet here all winter long, or should I take more time.

3. Would anyone like to share other suggestions, comments?

Thanks, I'll post pictures when I'm done.

Ed Beck

Re: Rubbing Poly finishes

#2

Re: Rubbing Poly finishes

Steve Schoene

>It's purely a matter of taste and the style of the furniture. Why not make a test board that you first rub to satin, and then later carry on the rubbing process to go to gloss.

While humidity does have an impact on curing time, the more important factor is temperature. If you are well below a normal temperature, say 70�, then you would want to add some time.

Re: Rubbing Poly finishes

#3

more specifically...

Michael Dresdner

>What Steve said is correct. Satin or gloss is strictly a personal preference.

As for drying time, provided the humidity is not excessive, temperature is indeed a bigger issue. However, if you ever hit anywhere above 85% relative humidity, everything changes. That's because at excessively high humidity, the driers in oil based finishes like varnish can become disabled. At that point the drying time reverts to what it would have been with no driers in the mix. For most oil based varnishes, that is roughly seven times longer.

The good news is that once the humidty does drop, the driers kick in again, so it is not a permanent problem. Thus, if you move it into a warmer, drier room, the finish will start curing as it should.

By the way, I also live in the PNW (I'm in Puyallup, WA) and can tell you that the humidity in this area is nearly perfect. It is never too wet in the summer, and indoor humidity in the winter is typically around 50%, also ideal, because it is the season when you heat your building. The only problem is if you try to finish in winter in an unheated garage. That's a bad idea. Otherwise, this is a great place for finishes.