Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Sanding & Repainting MDF

Posts

Sanding & Repainting MDF

#1

Sanding & Repainting MDF

Tom Gattiker

>I have not posted here for a couple of years since moving to a house with no room for a shop. Good to log on and see many familiar names and some new ones.

Need to repaint all my MDF kitchen cabinets. They have 2 coats of paint now. Latex I think. Pretty bad brush and run marks, which I want to remove before painting. I have had no experience painting/repainting MDF.

Using an orbital sander, can I sand these flat enought so they will look good? Or should I have them stripped or run thru a drum sander? I am concerned about hitting the mdf and creating depressions, etc. if I use a hand sander. Would a good solution be to apply a couple coats of primer before sanding--to enable me to sand out the brush marks without hitting the MDF?

If I do sand them, can anyone recommend a paper that will not load with paint terribly?

Other suggestions?

Thanks.

Re: Sanding & Repainting MDF

#2

Re: Sanding & Repainting MDF

Steve Schoene

>Stripping, particularly the doors and drawer fronts which can be removed to be worked on horizontally, and with serious ventilation is likely to be the superior way. Latex paint is not the choice for cabinets and sanding it off is likely to be a major exercise in frustration. When you repaint, use alkyd oil based enamel, or if waterborne finish is needed 100% acrylic enamel.

Re: Sanding & Repainting MDF

#3

Tom - one answer

Howard In Toronto

>I suspect hand sanding will be enough to knock down enough of the variances caused by brush strokes if you use a good quality self-levelling paint.

You're best going to a good paint store that deals with contractors, not the big-box stores.

But it does depend on how many doors you plan on sanding down.

It'll be slower than using an orbital sander but a lot easier to control.

Afterwards, you can touch it up - carefully - with an orbital sander.

If possible, one with VS using a low speed.

As for a good sandpaper, I'm partial to Norton 3X paper.

Available in sheets and various hole configs for orbital sanders.

Takes ages to load.

Real easy to clean on a gum block.

HTH

Howard