Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Solid Maple table

Posts

Solid Maple table

#1

Solid Maple table

Steve Jenkins, McKinney, TX.

>This is a 55"x55"x36"tall table made from solid maple. The top is about 1-3/4 thick. The glue up was done with titebond and no biscuits or anything in the long-grain joints. I made it about a year and a half ago and saw it a couple weeks ago when I delivered some more furniture. It is just as flat and solid as the day I delivered it. The legs go up through the top and are flush with the top. There is a 1/4" chamfer around the top and down the outside corner of the legs.the client didn't want any apron just a clean top and legs.

Steve


img

Re: Solid Maple table

#2

Re: Solid Maple table

George@Colonel's Workshop-Havertown PA

>Good Evening Steve,

That is a beautiful table which fits in with its space to perfection. The absence of an apron is very appealing. How did you join the legs to the top?

George

Re: Solid Maple table

#3

Never Mind, Steve. I see it now!

George@Colonel's Workshop-Havertown PA

>

Re: Solid Maple table

#4

I don't see what George sees...

Jim Rahbe, Bedford, TX

>Steve,

Long time no see� How is your new shop and house remodel coming along?

I can�t see what George sees, so tell us how the legs are connected to the top. I�m sure it is not so, because I know you do this for a living, but it �appears� that any sideward movement of the top would just collapse the legs. I�d be afraid to slide the table on that tile floor for fear of the bottom of the leg catching and folding under the table.

Jim R.

Re: Solid Maple table

#5

Neither do I

Dan Mitchell

>So how ARE the legs attached?

Dan

Re: Solid Maple table

#6

Re: Neither do I

Steve Jenkins, McKinney, TX.

>I glued the legs in place with the table upside down then at a shallow angle drilled two 3/8" diameter holes through the underside of the top into each face of the legs. I went in as far as I dared (I was worried about coming out the top). I then epoxied a 3/8" dowel about 4" long into each hole so there are four dowels in each leg. The legs are really quite solid although I suppose that if you laid the table on its side and sat on a leg it would crack loose. I told the folks that since they didn't want an apron on the table that they would have to be a bit more careful moving it.