Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Raised panels using MDF

Posts

Raised panels using MDF

#1

Raised panels using MDF

John_in_Az

>Greetings - I'll be attempting my first raised panel doors soon. I will use poplar for the rails and stiles and since they will be painted anyway I thought I would use MDF for the panels. I can see some benefits (stability and cost), but wonder how hard MDF will be on my bits. Any other downside and advice. Thanks, John

Re: Raised panels using MDF

#2

Re: Raised panels using MDF

George@Colonel's Workshop-Havertown PA

>Good Afternoon John,

I did about a dozen cabinet doors for my #2 son and his wife. They were painted poplar frame/MDF raised panels which were done on the router table. MDF works well, and I did not note any discernable dulling of the cutters. I took several passes to reach the desired depth and profile. They came out smooth and crisp.

George

Re: Raised panels using MDF

#3

Re: Raised panels using MDF

John_in_Az

>Thank you George for the response. You affirmed what I had read and know about using MDF. I don't mind spending the money for the right product for a job, but why spend more than is needed. I like the idea of saving not only cost but time and effort to glue up the panels. What I didn't want was to be foolish in the cost saving aspect and trash the expensive bits ie; no saving, lol. Thanks again, John

Re: Raised panels using MDF

#4

George had it right

Howard In Toronto

>But I'd like to add one more observation.

Clean the bits often.

The glue in MDF tends to build up similarly to pitch.

Otherwise George's advice was spot on.

Howard

Re: Raised panels using MDF

#5

George ALWAYS has it right

Mark Goodall - ATL - tooljunkie

>Guess it comes with experience!

Happy Woodworking!

Re: Raised panels using MDF

#6

All MDF is not the same

Keith Newton------WebKitFormBoundaryDZmgloT+ZiYFgX

>You may ask your supplier where ever you are what your options are. Some are rather softer than others, which may machine easier, but not cut / sand as smooth, but the harder ones would be harder on the bit. But surely getting a router bit sharpened would not cost too much? I sharpen my own, so I don't know what the normal charge is, but for two edges, it couldn't be much.

Re: Raised panels using MDF

#7

Re: Raised panels using MDF

John Ballance

>I've made several raised panel doors for my daughter's house using MDF for the panel. The only advice I'd offer beyond what George already provided is to set up some dust collection at your router table, AND wear a good dust mask. Routing MDF creates a cloud of dust -- you'll be wearing the dust before you are done with the panels, but the panels will look very nice.

I've not noticed any bit dulling from these activities.

Good luck.

Re: Raised panels using MDF

#8

Re: Raised panels using MDF

Scott Whiting - Glendale, AZ

>Because you do not have to allow for the expansion of the panel you can even make the panel without much slop and glue it in instead of floating. It then becomes part of the door structure. I've seen it done on entry doors too.

Re: Raised panels using MDF

#9

Re: Raised panels using MDF

John_in_Az

>Thank you all for your input. I especially like the idea of gluing the panels for strength due to the low movement of MDF. Also, thanks for the heads-up about the dust hazard. I was just going to use the paper type mask, but I think I'll break out the better cartidge type filter I have for painting. Gratefully, John