Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

OT - Plumbing problem

Posts

OT - Plumbing problem

#1

OT - Plumbing problem

Derek

>How would you fix this (I fixed it)?

The kitchen faucet water flow dropped way down all of a sudden. The rest of the faucets in the house are fine.

I closed the shut-offs, disconnected the hoses and opened the faucet.

Then I used my compressor to blow back from the faucet to clear the blockage at the valve. It worked nicely.

I never thought of doing this before, but it saved a lot of grief!

Re: OT - Plumbing problem

#2

Re: OT - Plumbing problem

Barry Irby

>I would have tried cleaning the strainers on the faucet first.

Next I would have turned the cutoff valves under the sink on and off a few times in hopes that whatever was in the system was stuck there and just moving the valves would dislodge it.

Would not have thought of blowing out the system. Thanks for the idea. Hope you flushed the system through the bathtub and or faucets with the strainers removed. Otherwise, whatever you blew loose will just get caught in your strainers.

I will keep this in mind.

Re: OT - Plumbing problem

#3

Re: OT - Plumbing problem

del schisler

>if this is a moen faucet It is garateed for life The problum with them Their is a small ball beiring in their that get lime on it and eather stick's and you get hot water and no cold It stick's at the bottom Cold no hot You can take the valve out You have remove the brass clip to get the valve out You may have to get a moen puller It is in their !!! I have seen them tore up getting them out You can take the white plastic piece off the bottom It is like a plug Take the beiring out and clean it and the inside real good put back and It will work tell next time On the garentee if you get it out and don't want to do the above task Take it to home depot and get the number of the cartrage like (1222) and than call moen phone number

1-800 buy moen they will send a free one hope's this helps del

Re: OT - Plumbing problem

#4

Re: OT - Plumbing problem

Derek

>Barry,

I forgot to mention - I did clean the strainers, but they were in the hand piece and I took that off and the problem was before the hand piece. It was obvious that it was at the valve.

Re: OT - Plumbing problem

#5

Easier solution

Mark Goodall - ATL - tooljunkie

>I would have just washed my dirty, oily, messy hands in the garage/workshop sink instead ;)

Happy Woodworking!

Re: OT - Plumbing problem

#6

Re: Easier solution

Derek

>I would have done that, but I though I could scare it into working! :>)