Re: It would be good if
Bill Sams
>Here's a pic of my sheet goods. In Andy Rae's "Workshop Idea Book" there are also many examples of storing sheet goods.
My system consists of 2x4 frame panels, sheathed only on the two ends and top and bottom. Each section allows for the thickness of about 6 pcs of 3/4" plywood to be stored and still allowing room to retrieve. Since I use alot of 5x5 sheets, I built this to accomodate both 5x5 and 4x8 sizes. Small spacer blocks to fit each section helps keep the sheets from slumping when there are only one or two sheets in each cell.
The entire unit is 10' tall, so above the 8' sections there are 2' sections available for scraps.
Make sure you make your opening 1" taller than your sheets goods, otherwise you will fight to get them in or out, ie 97" vs 96"
Hope that helps.
