Re: Paint for Garage Workshop
Larry Clinton At Frankfort (Central)., Indiana
>I used the Garage floor Epoxy kits by Rustoleum. I have the grey, with the speckled flakes (you sprinkle onto the floor after applying the epoxy). My floor was over a year old when I applied it and had already had oil, grease, stain, shellac etc spilled on the surface. (We had worked on vehicles in the shop so PS, Brake and transmission fluid had also been on the floor. In addition I had used a sealer/cure on the surface when it was poured. The container says the epoxy may not adhere to a "sealer". My shop is 30' X 30' so used about 3 kits. We did clean and rinse the floor very thoroughly using citrus cleaner, then the cleaner in the kit. We finished one half, let it dry for a couple days then cleaned and finished the other (Didn't want the big tools out in the open overnight). The performance has been excellent. I have a 20" stationary planer, Unisaw with extension tables & mobile base, 8" Grizzly joiner, MM-16 bandsaw, and large router table, 2 large tool cabinets / chests - everything is on mobile bases (and does get relocated often, dependent on the project we are building). We have also moved the equipment aside and rebuilt the motor on my sons Van in the shop, with all the attendant mess of fluids (they cleaned up easily when the job was done). It has been about 3 years now, and there is NO missing epoxy. There are a few scratches where I have caught something (gravel or nail) on a caster of the planer. Even then the coating didn't scratch through.I think the planer weighs 700+ lbs so didn't expect the coating to hold up near as well as it has. When / if it ever needs re-coating, I will use the same material again. It is not slick, has a semigloss surface - think the "sprinkles" keep anyone from slipping. I really like the appearance. I have cleaned areas with Acetone, Naptha, Alcohol etc. with no effect. I do have some glue spots here and there I should remove - someday maybe :~).