Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Dewalt 733 planer question

Posts

Dewalt 733 planer question

#1

Dewalt 733 planer question

scottinphoenix

>while planing some hickory i noticed the feed of my planer was hesitating{jumpy} After taking off the cover i noticed that the chains to the rear rubber feed roller sprockets were extremely loose.There doesnt seem to be any way to tighten the feed roller as the screws holding the bracket are tapped into the casting. And i cant see any missing teeth on the sprockets or excessive wear. Anyone have any ideas on a fix or the cause of the problem? TIA

Scott

Re: Dewalt 733 planer question

#2

Re: Dewalt 733 planer question

HC Sakman

>The graphite (sp?) square bushings, where the in and outfeed rollers are bedded, worn out. They are cheap but somewhat difficult to change. It's a good idea to turn the planer upside down after setting the cutterhead for maximum cut.

Chain is supposed to have a tensioner engaged, but still the chain looks sort of "loose" on the sprokets.

Chico...

Re: Dewalt 733 planer question

#3

Re: Dewalt 733 planer question

Larry Marker

>Have you tried their web site? You need to create an account (free) on ServiceNet -- they have some great movies to demonstrate how do repairs and preemptive maintenance.

Larry

Re: Dewalt 733 planer question

#4

Re: Dewalt 733 planer question

George (Oxford, NC)

>Preventive maintenance calls for three things. Wax the bed and extensions, clean the feed rollers and make sure you have sharp knives. Do these and you will have a sweet planer.

George