Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Shop Heat

Posts

Shop Heat

#1

Shop Heat

Bear

>I recently built a 16 foot by 24 foot addition to my garage to be used

as a wood shop a friend gave me a vent-less heater to heat it, but it puts to much moisture in the room. I was looking for some ideas as to a good source of heat for this size of room.

Re: Shop Heat

#2

Re: Shop Heat

Barry Irby

>My shop is smaller (14 X 22) and well insulated. I use a portable electric "barn" heater. I am near Richmond, VA. In really cold weather I use an infra red propane heater mounted on top of the a propane tank to knock the chill off. Actually have not used it for two years. Just go and turn the electric heater on about half an hour early and it does the job. You might find that two of them do a good job for you.

The only draw back on the heaters is that the thermostats on them suck. Way to wide a swing. So, If you rely on the stat, the shop is either too hot or too cold. Mine is really old, so maybe the newer ones will have a more sensitive Stat. My shop is generally only heated when I am working in it.

Re: Shop Heat

#3

Re: Shop Heat

Tony - Memphis

>My shop is 16x20x10 and well insulated too. I use a wall unit ac with strip heat. I keep it reasonable 24/7 and turn it up a bit when I am in there. Doesn't seem to cost that much. For reference, I am in Memphis, TN. Not much winter here.

Tony - no heat neated today - 73�

Re: Shop Heat

#4

Re: Shop Heat

Andre Mallegol

>My garage shop is 16 x 24 located in MA. I use a Reverberray LD 15-40 radiant heater. Fuel is propane, uses outside air for combustion and exhausts outside so no water vapor problems. Max output is 40k btu. Probably overkill but it keeps the shop at 60 degrees when 0 outside. Company techs are very helpful.

Re: Shop Heat

#5

Re: Shop Heat

Scott in Montana

>Bear

You don't mention where you are located so I can just tell you my experience.

In my 22 x 24 shop I have a ceiling mounted compact Hot Dog style natural gas furnace, and I hate it. It's noisy, it's windy, it's inefficient (all though advertised as very energy efficient), it doesn't heat evenly (although installed via manufacturer's suggestions), and it always seems to need an annual repair involving a $70 part.

A friend's shop has in-floor heat using a conventional gas water heater, and it is so much nicer. Even heat, quiet, efficient, and uniform warmth. Now I know this isn't an option for your already completed shop... but I was just wishing enviously. :O)

I hope you have a better heating experience than what I tolerate.

Scott in balmy Montana

Re: Shop Heat

#6

Re: Shop Heat

leadpipe58

>radiant Heat Is The Way To Go.I Worked In A Shop With This Heat.

It Seams To Heat You And Not Evey Thing In The Shop.The Best Thing I Liked About It Is When The Doors Were Opened It Reheated Very Quickly.In 5 Minutes We Had To Stop Ripping The Guy That Opened The Doors.

Re: Shop Heat

#7

Re: Shop Heat

don at central illinois

>I have a 14 X 24 add on to the garage with 8' foot ceilings and well insulated. Have a small ventless NG heater, keep it on the lowest setting and never gets below 60 degrees, no matter what the outside weather. Never had a problem with humidity.