Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

OT: Attaching cable to brick?

Posts

OT: Attaching cable to brick?

#1

OT: Attaching cable to brick?

David Hay @ Denver

>I'm trying to run some coax cable along the outside of the house to an antenna I plan to install. In several places, the previous owners had attached some cable to the brick wall using coax cable staples. However, when I try to hammer one in (in the mortar, not the brick itself), the nail promptly bends. Any suggestions for how to attach this cable to the brick?

Thanks!

David

Re: OT: Attaching cable to brick?

#2

Re: OT: Attaching cable to brick?

Hamish

>Make sure the nails are steel nails and not wire ones.

Re: OT: Attaching cable to brick?

#3

Re: OT: Attaching cable to brick?

Glenn Madsen, near San Francisco

>You may want to consider an adhesive, rather than cable staples. Something exterior that will stick to plastic.

How long a run do you have over the brick? Is it possible to attach to the rafter tails or soffit, rather than the brick?

Re: OT: Attaching cable to brick?

#4

Re: OT: Attaching cable to brick?

John McGaw

>Are you using staples or the standard little plastic coax clips with the steel nail? I've used scores of the latter and have never had a problem. Oh, maybe 1 in 20 might bend but never more than that. I've even put them into the admittedly soft 1860s brick the house is built with. Could it be that you got a bad batch of fasteners? If you have to you could always go the route of drilling for plastic anchors and using stainless screws to hold suitable plastic clips but I prefer not to drill unless I'm absolutely forced to.

Re: OT: Attaching cable to brick?

#5

Re: OT: Attaching cable to brick?

David Hay @ Denver

>Thanks for all the help! I think that what I have is intended for a wood application and is a wire nail...not steel. I intend to limit the amount of cable I have to attach to the brick and run it along the soffit as much as possible. The clips that were installed by the previous owner seem to be pretty solidly attached...I pop the nail head off before it comes out of the wall! So I think once I get the right kind of clip, they'll hold just fine.

Thanks!

David

Re: OT: Attaching cable to brick?

#6

Bigger hammer?

Clint Searl, at the base of Haycock Mtn

>

Re: OT: Attaching cable to brick?

#7

Re: Just bends the nail faster ;)

David Hay @ Denver

>

Re: OT: Attaching cable to brick?

#8

Rick L

Re: Hotmelt glue

Rick L

>