Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Wood drying Black Walnut question

Posts

Wood drying Black Walnut question

#1

Wood drying Black Walnut question

Todd Nebel

>Hi, I bought some rough sawn 4/4 Black Walnut that has been stacked outside for who knows how long under a roof, some what exposed to all weather. I four sided half the pile down to between 3/4 - 7/8 and various lenghts from 2'-5'.

It is between 14% - 15% mosture now and is starting to show signs of movement in just one day as it is drying in my basement. Should I stack it flat on itself or with sticker it? What's the plus/minus of each approach? I'm in no rush to use it.

Should I do the same to the rest of the pile or leave it rough sawn and let it dry that way? What's the plus/minus of leaving it that way? Should I stack or stick it too?

Thanks, Todd

Re: Wood drying Black Walnut question

#2

Re: Wood drying Black Walnut question

John K Jordan

>>...Should I stack it flat on itself or with sticker it?

If you want to air dry it inside, you must allow air to get to each side of either surfaced or rough boards, either by stickering under weight (which may help to keep it flat), or by standing vertically. If the boards are in contact, they 1) will not dry, and 2) may mold and stain. Keep the stack some distance (4"-8" or so) off the floor, especially a concrete floor which may hold moisture.

If you let it dry roughsawn, you can joint or plane away some of the warpage. If you surface it first, you will have less wood to work with when resurfacing later.

If you want to do a little research, the WoodWeb and the Forestry Forum both have drying information in archives, knowledgebase, and on the forums. Air drying lumber has also been discussed on WC.

JKJ

Re: Wood drying Black Walnut question

#3

Re: Wood drying Black Walnut question

Barry Irby

>John nailed it.

I would bring it inside and either sticker it with weight on top or stand it vertically. And, if you leave it rough, you will have a little more to work with when the time comes to prepare it.

I have made several pieces of furniture out of air dried walnut and have had not trouble with it, but I brought it into the house and let it acclimate before I used it. My thinking is that the furniture will end up in the house and both air dried and kiln dried lumber eventually arrive at an acclimated condition to whatever space they are in. So let the lumber adjust first and then build the furniture and you will get minimal change after. Works for me so far.