Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Making Plywood

Posts

Making Plywood

#1

Making Plywood

Wess in NJ

>I have a project in mind where I will need a panel (probably cherry) that will be about 18" wide by 30" long. The design will have the panel captured on four sides by a frame but I need to glue it solid for strength. I know a veneer over substrate would be the obvious answer but a carving is to be done so that will not work. So, (finally) my question is, if I were to resaw some solid stock to say 1/16" thick laminations and cross the grain like plywood and then press the whole thing together would it stop the cross grain expansion?

Re: Making Plywood

#2

Lee Grindinger

Yup, it will work just fine

Lee Grindinger

>Wood is so much stronger along the grain than across the grain that cross grain laminations take on the characteristics of long grain when restrained by long grain. By exploiting this plywood expands and contracts in both directions at the same rate as the long grain as the species concerned, in this case cherry.

You will have cross grain laminations showing in your carving, however, and if you remove large portions of face veneers it will cause the panel to become imbalanced resulting in a non-flat panel. Balance is what makes plywood flat and messing with that balance too much will cause problems.

Lee

Re: Making Plywood

#3

Re: Yup, it will work just fine

Dom Russo

>Wess,

I agree with Lee. It might work to constrain the cross grain expansion, but could warp if you start cutting through the laminations. Though you might think there is no way to allow for expansion, there almost always is a modification to the plan that would allow for a solid piece. Good Luck!

Dom Russo