Shaker Table from a 2x4...
Rob Hix - King George, VA
>Hey all,
I thought I would post a picture or two of the table that I made for the Lumberjocks.com 2x4 contest that just closed. The first reason I wanted to post the pictures is because I am proud of what I squeezed out of a 2x4. Secondly, except for a couple of things, I am proud of the table. Finally, I got quite a few ideas for the dovetail jig to make the mortises for the legs from this forum. Well, here are the pictures.
![]() | ![]() |
The table is made from a single eight foot construction 2x4. It stands about 25" tall, and the top is 16" in diameter. It is finished with three coats of brushed on satin polyurethane and rubbed out with 0000 steel wool and Johnson's paste wax.
I ended up using the jig that was in the article title "Tilt Top Table" by Mario Rodriguez that appeared in the November/December 2004 issue of Fine Woodworking. I made the jig to last because I love to make Shaker furniture, and I feel like I will need the jig again a few times in the future.
The project was fun, but had its challenges. This was the first experience I had had with sliding dovetails, and this is the first piece I got to use my lathe on. The only thing I am not happy with is the finish and the fit of the legs. I am not good at all when it comes to brushing on polyurethane. Maybe one day I will learn that wipe-on is for me. The legs fit ok, but even with flattening off the pedestal for the legs, I still did not get a really good fit. I think part of that has to do with using pine.
Overall, it is presentable, and I am looking forward to building more sometime.
Thanks for looking,
Rob Hix





