Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Staining help needed - two-tone cabinet door

Posts

Staining help needed - two-tone cabinet door

#1

Staining help needed - two-tone cabinet door

Cody Lewis in LV

>I'm making a couple cabinet doors and I'd like to have the panels a lighter color than the edges (rail and stile). I was planning to make all the necessary cuts, then do all the staining on the disassembled pieces, then glue it up for a finished product. The problem is that I'd really like to route the edges of the assembled cabinet door to match the edges I've done on the rest of the project, but this can only be done if all the assembly is completely done, and this obviously will create an unfinished edge (raw wood).

So here's the question: If I were to assemble the entire cabinet door before staining, and if I taped off the panel, would the tape prevent the dark stain from getting to the panel?

Seems like the dark stain would bleed thru the tape and "infect" the panel, making it impossible to leave it lighter than the rest. Please give any and all suggestions.

Re: Staining help needed - two-tone cabinet door

#2

Lee Grindinger

Completely finish the panel before assembly

Lee Grindinger

>Finish the panel with a film that won't allow penetration of stain, this is actually the ideal way to do frame and panels anyway. Leave the frame unfinished, assemble, then mask the panel for finish on the frame.

Lee

Re: Staining help needed - two-tone cabinet door

#3

Re: Staining help needed - two-tone cabinet door

Dave Arbuckle, Plano, TX

>Once you've done it the way Lee recommends, I suspect you'll do it that way all the time. Even when the frame and panel are getting the same finish, it's just easier to have the panel already finished.

You do want to plan to be a bit careful about final sanding the frame after assembly. A little slip onto the panel can be kind of embarassing.

Re: Staining help needed - two-tone cabinet door

#4

Re: Completely finish the panel before assembly

Cody Lewis in LV

>Thanks for the help. By "finish the panel with a film" do you mean stain to the desired color and seal it with a polyuerethane (sp?) finish?