Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

minwax oil stain question

Posts

minwax oil stain question

#1

minwax oil stain question

Lee Beeden

>I have just finished some fir doors with miniwax's 'Penetrates, Stains & Seals' oil finish, over a coat of 'wood conditioner'.

The panels are actually fir plywood(very nice). However they were a little sloppy in the grove because the fir is actually 3/16 and my cope and stile bit has milled a 1/4" groove. I reinforced with floating tenons.

The stain went on well, however on inspection this morning there must have been some excess stain hidden in the cope and stile groove. This has caused some dark spots around the edges which have become stubborn to remove. Paint thinner does not seem to work. I need a way to thin and blend the patches in.

Any suggestions?

Thanking you all in advance!!!

Lee

Re: minwax oil stain question

#2

Re: minwax oil stain question

John Veerkamp

>you may need to sand lightly in the corners with fine paper, maybe 320. When oil stain dries it is usually no longer soluable.

John

Re: minwax oil stain question

#3

Ellis Walentine

Scrapers

Ellis Walentine

>You won't dissolve the dried bleed-out, Lee, unless you use some kind of paint/varnish remover. The simpler alternative might be to use a chisel or a hand scraper to take off the major blebs, and then backfill with a little stain on a rag in those areas where you expose bare wood.

In the future, with any oil stain or finish, it is a good idea to keep an eye on things, so you can catch any bleed-out before it dries. This is particularly a problem with open-pored woods like red oak.

Ellis Walentine, Host

Re: minwax oil stain question

#4

Re: minwax oil stain question

Michael Wilkins

>From experience, you will have to use Mineral Spirits to try and remove some of the excess, or resort to a stripper. Messy at best.

Try the spirits method first before applying any finish.

Hindsight being what it is, you may want to consider finishing any panels prior to assembly, just to prevent such a scenario.

Good luck and watch those fingers.