Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

Electrical Gremlin Question

Posts

Electrical Gremlin Question

#1

Electrical Gremlin Question

Nat Robison

>I know a bit about wiring but less about troubleshooting problems. I finished a portion of my basement over the past year and just encountered an electrical hiccup this past weekend.

One of the rooms is serviced by a single 15-amp circuit (14 ga. wire). The wire comes from the main and feeds about 6 outlets before going to a switch and then to a couple of recessed lights. I flipped the light switch and no light. I checked that the breaker hadn't tripped (it hadn't). I decided to check the outlets by plugging in a fan to see if there was power at each outlet. The outlets were all fine but at the 4th outlet, I plugged in the fan and the lights came on at the same moment (I had left the switch on).

Everything looks tight in the switch box. Any thoughts as to the problem and where to look next?

Re: Electrical Gremlin Question

#2

Re: Electrical Gremlin Question

Chuck W

>You likely have the switch in series with the plug somehow or that last plug is wired in series rather than parallel connections. Just to review basic electrical connections...the plugs are across the hot and neutral, ie white wire to silver terminal and black to brass terminal. The switch should come off the hot wire, go to the lights, and back to the neutral and the bare copper should connect all electrical boxes.

Re: Electrical Gremlin Question

#3

Clarification to original post

Nat Robison

>I forgot to mention that this is the first time this has happened. The lights have functioned normally for since I did the wiring.

Re: Electrical Gremlin Question

#4

Re: Bad /Intermittent Connection

Philip

>Given that this circuit worked fine once upon a time (and assuming you don't have any other complicating factors, such as a ground fault outlet somewhere in the circuit) It sounds like it could be as simple as a bad connection in the box where you plugged in the fan when the lights came on: I'd check all these connections again.

Re: Electrical Gremlin Question

#5

LOL ! Been there, done that. Re-done that.

steve mackay

>

Re: Electrical Gremlin Question

#6

Re: Agree, bad connection or outlet

Brian in Brighton

>

Re: Electrical Gremlin Question

#7

Re: Electrical Gremlin Question

Keith Newton------WebKitFormBoundaryDZmgloT+ZiYFgX

>You didn't say how you hooked up the wires to that fourth receptacle . I suspect that you used the inserts in the back? If so, you may get it to work by removing them and using the screws, which I think are more reliable. Or just replace that receptacle.

If that doesn't work let us know, and give more specific info on how the neutral is run.

Re: Electrical Gremlin Question

#8

There's a simple answer

Lee Schierer - McKean, PA

>Most likely you wired everything corectly. The problem is in the switch. LOML has the same problem with some of the "quiet" switches I installed in our kitchen a few years ago. It seems that these quiet switches don't always turn on when you flip them to the on position. The lubricant inside seems to dry out and the swich will stick in the off position. If you leave it in the on position, sometimes it will break free on its own and turn on.

Replace the switch with a new one, preferably with a non silent type.

By the way, I'm not an expert, but it appears that you may have too many outlets and lights combined on a 14 ga wire circuit depending on the amp rating of the circuit breaker. NEC doesn't list the maximum number of receptacles you can put in a circuit, but you should make sure the circuit breaker is correct for the wire gauge (15 Amp is the correct breaker for 14 ga)

Lee