Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Jointer Gloat

Posts

Jointer Gloat

#1

Bart Goldberg

Jointer Gloat

Bart Goldberg

>Well, I finally got around to installing that new spiral cutterhead on my Delta DJ-20 Jointer. It took about 2 hours to complete. One added bonus - while taking apart the machine, we noticed a "screen" that was put on the underside of the cutter head as a safety, but that greatly interferes with dust collection. Just two screws to remove, and the chip removal capabilities of my jointer improved by a thousand percent.

Took a few test cuts - leaves a real smooth surface and is also much quieter that the 3 knife cutter head it replaced.

Now - does anyone need a 3 knife cutter head for a DJ-20?

Bart

Re: Jointer Gloat

#2

JL

Re: Jointer Gloat

JL

>Hmmm - I wonder if it will fit on my Steel City? The two machines look very similar.

Re: Jointer Gloat

#3

Bart Goldberg

Re: Jointer Gloat

Bart Goldberg

>I also have a set of Amana t1 steel Jointer knives that are practically new.

Re: Jointer Gloat

#4

Re: Jointer Gloat

John Hollaway

>Hi Bart:

I have a DJ-20 myself and was thinking of doing the same thing. Which spiral cutterhead did you use? How much $$.$$ did you get into the job? Age of DJ-20 or origin of the machine's manufacturing make any difference? Any reservations or second thoughts? Thanks.

Re: Jointer Gloat

#5

Bart Goldberg

Re: Jointer Gloat

Bart Goldberg

>Hi John,

I purchased the Spiral Cutter Head from Byrd Tool Co. The cutterhead cost around $450.00. I had previously purchased the Dispos a blade system and found that it wasn't up to my expectations so I sent it back for a refund. The dispos a blade system was around 300 - so for another 150 bucks I could upgrade to the Spiral cutter head -a much better investment IMHO.

I don't know the age of my DJ-20 cause I bought it used.

I did spend the extra money to replace the bearings as well - Its a good idea to replace them while you have the cutter head removed. I don't recall the price for the bearings - but it wasn't that much extra.

Any 2nd thoughts - No! The performance of the new cutterhead is incredible and the noise reduction was a nice bonus.

BTW - when you have the cutter head removed, I highly recommend that you also remove the screen material underneath. Removing the screen will greatly improve the machines dust collection system.

Good Luck

Bart