Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

undersized plywood dado

Posts

undersized plywood dado

#1

undersized plywood dado

les winter

>I'm going to be making up some kitchen cabinet doors using solid wood for the rails and stiles, and 1/4" plywood for the panel. I'd like to machine the dado on my table saw. My freud dado set doesn't cut much smaller than a light 1/4". I'm thinking of trying a pair of 7 1/4" circular saw blades with a bit of shim between them to get the undersized plywood to fit right. I really don't want to route the groove. Any input would be welcome.

thanks

Les

Re: undersized plywood dado

#2

Re: undersized plywood dado

Barry Irby

>"Norm's" method is to cut it with your favorite blade in two passes.

Set the blade to the correct height and fence slightly off center. Using scraps with Identical thickness, run them through the blade and then reverse it and run it with the other face against the fence. This assures the dado or groove is centered in the stock. You just have to fiddle the fence setting until you get the groove you want.

This does not take as long as it sounds like, unless you are making thousands of pieces. Since you don't have to even remove the existing blade from the TS, you don't have to take the time it takes to install the two blades and figuring out what the spacer would be.

Re: undersized plywood dado

#3

Re: undersized plywood dado

Jim Dillon

>Les,

The method suggested by Barry has always worked well for me as well, especially for stiles and rails of equal thickness. However, for stiles and rails of different thickness, to keep from getting confused, I mark the backside on all the pieces and keep that side against the fence. Then, after making the initial cut, just move the fence slightly - always keeping the marked side against the fence. Keep a practice piece handy to check your setting. In fact, keep several practice pieces handy 8-). Oh yes, watch out for plywood that varies in thickness. Hope this helps.

Jim

Re: undersized plywood dado

#4

Re: undersized plywood dado

Ed Mulligan, Cape Cod

>IME a thin-kerf (3/32) blade is too thin for the double pass method. You will need a 1/8" kerf blade. Ed

Re: undersized plywood dado

#5

Re: undersized plywood dado

steve mackay

>Ive used, sometimes, SEVERAL passes for grooves and daddos. As said above, doesn't take to awfully long. Stacking TS blades sounds evil to me though.

Re: undersized plywood dado

#6

Re: undersized plywood dado

Ron

>You may want to check out some of the wobble dado blades. Mine allows me to dial in the 1/4 inch plywood. However it does leave you with a less than flat groove.

Ron

Re: undersized plywood dado

#7

Re: undersized plywood dado *LINK*

Charles M

>Les,

Even though you said you prefer not to use a router, I think your best option is this adjustable set that will make T&G from 7/32" to 3/8" and was designed to do exactly what you want. It even has opposing shear angles on the tongue cutter to reduce chipping on the rail ends:

Charles M

Freud America, Inc.


img

Freud 99-036 Adjustable Tongue and Groove Bits