Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Performax 16-32 belt memory?

Posts

Performax 16-32 belt memory?

#1

Performax 16-32 belt memory?

Jim in VA

>I purchased my 16-32 before Performax was sold to Jet. Used it briefly, but then stored it away for a few years. I just tried setting it up today and noticed that the conveyor belt had developed a memory of the end rollers. So now there are two little humps as the belt moves around. Any way to get rid of them? Or do I need a new conveyor belt?

Also, anyone know if the currently sold outfeed extensions will fit this machine?

Re: Performax 16-32 belt memory?

#2

Re: Performax 16-32 belt memory?

Ron Hildreth

>Jim,

Not sure if this would work or not, but have you tried letting it run for awhile, maybe half to a full hour, while you're close at hand doing other things, but keeping an eye on it? I did this with my 22-44 after it had set awhile, and the humps came out of it. Mine might not have been as bad. I now try to remember to turn the feed belt at least once a week to prevent this. BTW- thanks for reminding me!

As for the extension tables, I know I can get them for my 22-44, but sorry, not sure about the smaller 16-32 PerformaX.

Ron in Iowa

Re: Performax 16-32 belt memory?

#3

Re: Run It

Mark Mandell - Gone Round In Jersey

>for a while after you tighten up on the belt tensioners about a turn.

If you want to get extreme about it, use a blow-drier to warm the belt as it's running; just make sure to do it evenly.

FNO, when you put the machine away, take some tension (2-4 turns) off the belt, like you should with your bandsaw blade [assuming you have a bandsaw].

mm

Re: Performax 16-32 belt memory?

#4

Re: Performax 16-32 belt memory?

Robert R Clough - Thorncraft

>Jim

I sent you an e-mail re: the outfeed tables.