Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

OT-Water Pressure Regulator

Posts

OT-Water Pressure Regulator

#1

OT-Water Pressure Regulator

Ron Hildreth

>Over the past three or so years that we've had our tankless water heater, we've been pretty happy with it, that is until about a month ago. We've been plagged with the problem of it cycling - hot, cold, hot, cold, during the coarse of a shower. I think I've narrowed the source of the problem down to our cities fluctuating water pressure. Several people here in town have noticed it. I've talked to the water department - they're aware of it, but I was told that it's not a problem as far as they are concerned, and until something really big developes from it, it won't get fixed.

With that said, what I'd like to try is a water regulator I can adjust slightly below the lowest pressure we receive from the city, installed before the heater, and I then can adjust my tankless water heater to achieve a uniform hot shower for any length of time I want. I'm tired of searching for the hot/cold water adjustment with soap in my eyes!

I'm no plumber by any means, so looking for any info the wide knowledge base here might have. Will it work? Any better ideas?

Thanks!!

BTW- a tankless water heater is very pressure sensitive!

Ron in Iowa

Re: OT-Water Pressure Regulator

#2

Re: OT-Should have a household one already.

Brian in Brighton

>Ron, Look at your incoming water system for the house. You probably already have a pressure regulator inline. Our's is set for 50 psi from the factory. You can adjust it easy enough, just be careful you don't go too low or too high. If you want to put one in front of your water heater you can do that too. It will need to be set at least 5 psi less than the incoming line to get a good resolution on the regulator.

See a good plumbing store about it. They are easy enough to put in. Just be sure you have the water flow going the right way.

Brian in Brighton

Re: OT-Water Pressure Regulator

#3

Re: OT-Water Pressure Regulator

Glenn Madsen, near San Francisco

>It may mean little to you, but our water pressure problems were solved when the folks down the street found that their connection to the main had 'let go' 6' under the street. When the water department dug up and repaired that break, we got consistently better performance from our water supply.

Our only challenge was that they cut off the supply in the late afternoon, when someone here needed a shower before a late in the day appointment...

Re: OT-Water Pressure Regulator

#4

Jim DeLaney, Austintown, Ohio

Re: OT-Water Pressure Regulator

Jim DeLaney, Austintown, Ohio

>I recently replaced the fifteen year old regulator on my water line. Here, I have the opposite problem from you - the city supplied water is at 135~150 psi!

A �", all brass regulator cost me $68.00 at a local plumbing supply. Since the fittings were already sweated onto my lines, replacement of the regulator only took about ten minutes, but even if I'd have had to cut the supply line and sweat on the fittings, it would have been less than an hour. The new regulator is adjustable, but was factory pre-set at 50 psi, so I just left it at that.

One caveat: The regulator also acts as an anti-backflow valve, so if you have a pressure build-up problem (common with a conventional water heater) then you'll also need an expansion tank somewhere within the system. Mine is right next to the water heater, suspended from the basement ceiling. It's about the size of a baskerball.

Hope this helps...

Jim D.