Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

OT: Double Deadbolt--secure from inside?

Posts

OT: Double Deadbolt--secure from inside?

#1

OT: Double Deadbolt--secure from inside?

Henry Higginbotham

>In a attempt to make my shop more secure (or at least slow the bad guys down somewhat), I bought a couple of double-cylinder deadbolts for the doors. The idea is, if someone gets in through a window then at least he'll have to take my stuff OUT through the window, and maybe attract more attention in the process.

But it sure LOOKS like, once inside and out of view, someone could just remove the long screws holding the interior part to the exterior part and turn the latch with a screwdriver. I didn't try it because I'd had enough of the cold for one day and came back to the house.

Am I missing something? Once it's locked, does something besides the screws hold the two pieces together? I've Googled around fairly diligently without finding anyone commenting on the matter, one way or the other, with the exception of one manufacturer that provides ball bearings just the right size to hammer into the socket-head screws, thus making it just about impossible for a burglar OR the owner to ever remove the lock.

Henry

Re: OT: Double Deadbolt--secure from inside?

#2

JL

Re: OT: Double Deadbolt--secure from inside?

JL

>See about getting some "one-way" screws if you are that worried about it. These require a lot of effort to remove - though they can be removed with the correct tool. I've seen them in a variety of sizes.

Re: OT: Double Deadbolt--secure from inside?

#3

Re: OT: Double Deadbolt--secure from inside?

Dave LaPine

>I just got done doing the same thing. Included with your new cylinders there should be some small color matched metal plugs to drive into the holes once the screws are installed.

Re: OT: Double Deadbolt--secure from inside?

#4

Re: OT: Double Deadbolt--secure from inside?

Barry Irby

>Henry,

You did not mention whether your shop was attached to your house or not. If it is, there may be a Code issue. Most Building Codes no longer permitted keyed locks on the inside of doors hat might be part of the "egress" route out of the house int he event of an emergency. (fire, home invasion, etc.) These locks lock you IN as well as locking them Out.

If this is not a concern for you, you might still consider hanging a key someplace you can find it easily but that the bad guys won't see it. Like on the edge of the door facing down low, in case you have to crawl up to the door.

And, if you can find them you could switch to some type of screws with an unusual screw slot or drive. (Check with a full service locksmith.) Then hide the driver for them. If you don't have the little plugs, you could also plug the screws with epoxy. Then if you needed to, you could remove the epoxy with a heat gun or torch.

Re: OT: Double Deadbolt--secure from inside?

#5

Re: Thanks to everyone

Henry Higginbotham

>Barry, the shop is not attached so no code issues there, plus I can't imagine ever wanting to have both doors deadbolted while I'm in the shop, although I'm sure I'll seldom remember to unlock the back door when I'm working out there, so the hidden key is probably a good idea.

Epoxy is probably my best bet for security, too. A local, non-woodworking friend had already suggested JB Weld, and I figure that if it's ever necessary I can clean it out with a needle-nosed carbide burr in a Dremel tool. That should slow 'em way down, anyway.