But if you do...
Joe Pack------WebKitFormBoundary+ck8IvgEXURxWCEA
>If you do try to trim a 3/4" inch piece off, you may have better luck by "tapping and running" than by snapping off a small, long piece. (Short, 3" or under, thin pieces are no problem to snap off with your fingers. It is the long pieces where you cannot control the direction of pressure that present the problem.)
This is the method I used to make thin, long strips from some VERY expensive, swirly, patterned glass for a custom order a few years back.
To "tap and run," make you score line as you normally would, then, place the glass, scored side down, on a piece of corrugated cardboard, thin carpet, a rubber router grip mat, etc...something with a bit of give, but not too much. Using the ball end of your cutter or some other fairly light, round metal object, begin tapping directly over the score at one end of the glass. Tap slightly harder until you see a crack developing at the score line. As the crack "runs" down the score line, keep moving up the score as the crack develops, tapping and "running" the crack the full length of the glass.
Your final edge will not be as smooth as a snapped edge, but a quick touch with a file or other metal object will get rid of the little shards that will develop along the edge.