Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Kreg pocket screw system

Posts

Kreg pocket screw system

#1

Kreg pocket screw system

richard jones

>Looking to get SLIGHTLY into this, am looking at the least expensive jig they have, the mini I believe they call it. My question: Looks as if the coarse 8-1 1/4 OR 8-1 1/2 screw is the one to use, but which one?

Thanks in advance.

rich in va

Re: Kreg pocket screw system

#2

Jason Roehl in Lafayette, IN

Depends...

Jason Roehl in Lafayette, IN

>...on what you are putting together. Coarse threaded screws are for softwoods like pine and poplar. Use fine threaded for hardwoods such as oak, maple, cherry, etc. As for length, it depends on the thickness of the materials you are putting together. The literature for my K2000 indicates that a 1-1/4" screw is used for 3/4" thick material.

Jason

Re: Kreg pocket screw system

#3

Re: Kreg pocket screw system

David Yoho

>Rich, as Jason said, it depends on the type of wood you are using and the thickness. I have a selection of sizes and thread types for that reason. I mainly use 1 1/4" length but it's handy to have longer and shorter sizes when needed too.

David - also in va

Re: Kreg pocket screw system

#4

Also Check Out Penn State Industries' Clone

George@Colonel's Workshop-Havertown PA

>

Re: Kreg pocket screw system

#5

Re: Kreg pocket screw system

Hal Smith

>Jason is right. Use 1-1/4" for 3/4" material. 1-1/2" would penetrate sthe far side of the material. Fine for hardwoods, coarse for softwoods.

Re: Kreg pocket screw system

#6

Re: Kreg pocket screw system

richard jones

>Thanks guys, exactly what I was looking for. As I only do hardwood, looks like the 1 1/4 fine will be just the ticket.

Thanks again.

rich in va