Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Freud 3 1/2" Raised Panel Bit with Dewalt 618?

Posts

Freud 3 1/2" Raised Panel Bit with Dewalt 618?

#1

Freud 3 1/2" Raised Panel Bit with Dewalt 618?

Dave W

>I'm contemplating making some furniture out of 3/4" MDF which involves some raised panel doors. Not a whole kitchen, just a few boxes. I'd like to use a Freud 3 1/2" Raised Raised panel bit.

The only router that I have is a DeWalt 618 2 1/4 hp dual-base kit.

I do have a router table.

Will the router be able to do the job if I make multiple passes with this bit?

Thanks for any help that you can offer.

Dave W.

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

#2

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

George@Colonel's Workshop-Havertown PA

>Good Afternoon Dave,

Assuming you can not vary the router speed, you should be okay if you take multiple shallow passes. I always make multiple passes even slowed down--just not as many.

George

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

#3

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

Dave W

>Actually, this is a variable speed router so I can slow it down to I believe 6,000 RPM. I'll set the speed to the lowest setting and then I guess I'll just play it by ear as far as how many passes to take.

Thanks for your help.

Dave W.

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

#4

The speed range is from 6 to 24 thousand in

Art Silva

>five increments which might be given in the owner's manual. A 3-1/2" diam. bit should be run in the 8 to 10 thousand RPM range. Most bit makers peg their maximum speeds at 10,000 FPM peripheral speed, more commonly called tip speed. At 10,000 RPM you will be a hair under the limit. Depending on the wood, you might get a clean cut at 8000 RPM, but you should plan on making at least three passes. Good luck. Art

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

#5

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

Charles M

>Dave,

You need to consult the User's manual for the router to determine the maximum bit diameter it can accept. Only DeWalt can answer your question.

Charles M

Freud America, Inc.

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

#6

Re: Freud 3 1/2" Raised Panel Bit with Dewalt 618?

Dave W

>Thanks guys for the good information. I'll check the router's manual to see if it can handle the bit. If so, I'll do 3 passes as recommended.

Dave W.