Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Delta 22-580 planer feed probs

Posts

Delta 22-580 planer feed probs

#1

Delta 22-580 planer feed probs

Dave Winters

>My Delta 22-580 has developed a balky feed rate that's kinda wierd;

With power on, the roller is turning. When I push a board in, it feeds it about 6" and stops. Then if I push, it'll feed another 6" and stop again. And so on. I cleaned the feed roller, but I'm sure that's not it..

Must be a slipping drive belt or something?

Anybody have this prob with this tool? Hard or easy fix?

As always, thanks!

Dave

Re: Delta 22-580 planer feed probs

#2

Re: Delta 22-580 planer feed probs

Steven Roxberg

>1. Clean the feed rollers

2. Wax the table to make it slicker

3. Replace the blades

If you do those three things you should have the problem solved.

Re: Delta 22-580 planer feed probs

#3

Re: Delta 22-580 planer feed probs

Dave Winters

>Steven- Thanks, but I really don't think that's it. Knives are relatively new and as I said, the roller is clean...

Re: Delta 22-580 planer feed probs

#4

but what about waxing the table?

henthorn

>

Re: Delta 22-580 planer feed probs

#5

Re: but what about waxing the table?

Steve Schoene

>I know from recent experience that waxing the tables can effect a dramatic improvement in feeding. I recommissioned my planer after being in storage for a few months. The bed was clean with no rust or other obvious problems but feeding was balky--enough so that I was considering calling in technical assistance. But, when I waxed the bed it became a new machine. That's now become a regular maintenance for me.

Re: Delta 22-580 planer feed probs

#6

Re: but what about waxing the table?

Dave Winters

>I'll give that a shot and report back..

Thanks, guys.

Re: Delta 22-580 planer feed probs

#7

Rick L

Re: Waxing the table....

Rick L

>takes care of this usually like the others said. When I worked for a deealer as a tech half the planers service calls I made just needed the bed waxed. You should have seen the faces on the folks when I "fixed" the planer. Mostly it was schools but also a fair amount of businesses.

Re: Delta 22-580 planer feed probs

#8

Re: Delta 22-580 planer feed probs

Stephen Kirk in Quakertown, PA

>I have the same planer and it does this occasionally. Even if the rollers are clean, clean them again. I use some soapy water and one of those green scrubbing pads. It's a pain because you have to keep turning the planer on and off to clean the rollers. Make sure you unplug each time! Definitely wax the bed, too. Whenever I have the feed problems, I do those two things and it works fine.

If you start seeing bad tearout (even after planing in the other direction) or really slow feed rater then your knives are probably getting dull.