Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Cleaning Metal for Paint

Posts

Cleaning Metal for Paint

#1

Cleaning Metal for Paint

awh

>I have a few pieces of angle iron that I bought from Home Depot, it's being used for a heavy-duty shelf in the shop so it's kind of on-topic. :) The metal appears to have some sort of a black powdery coating on it and it comes off easily by just handling them. This is different from the light-gray coating I have seen on metal I've used in the past. After wiping it down with lacquer thinner 5-6 times I'm still getting some of the black coating off on the rag - what do I need to do to clean it for paint? Spray primer & enamel are all I'm trying to put on it.

TIA



Tony Haukap

Home Page - http://www.cyberspace.org/~awh/

--

Re: Cleaning Metal for Paint

#2

Re: Cleaning Metal for Paint

John Veerkamp

>Try mineral spirits . Most of the coatings from manufacturing are oil based and should clean up that way. Use a good metal primer with rust inhibitors and you'll be fine.

John

Re: Cleaning Metal for Paint

#3

Wire brush & phosphoric acid wash

Clint Searl, at the base of Haycock Mtn

>

Re: Cleaning Metal for Paint

#4

Re: Cleaning Metal for Paint

JohnKJordan in East TN

>If you have purchased hot-rolled steel as opposed to cold-rolled steel (almost certainly if this is angle iron), the black may be mill scale. Mill scale is an oxide of iron, primarily Fe3O4, formed on hot-rolled steel because it is rolled to final size while hot enough to oxidize. Mill scale is usually tightly bonded to the steel. I'm guessing the powdery coating you see may be mill scale dust abraded from the surface by handling.

For wire welding, I always remove even bonded mill scale by grinding or sanding in the area of the weld. For painting, I don't remove it unless it is loose and flaking. I just prime and paint, sometimes after light sanding. From my experience, it is far more important to remove all rust than it is to remove scale.

Fabricators in the steel industry remove mill scale by acid or grit blasting, occasionally by wire brushing. (Long ago I was a steel and welding inspector.) I think this is done primarily if required by contract spec - I wouldn't bother with shelf brackets.

JKJ