Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Unisaw Belt question

Posts

Unisaw Belt question

#1

Unisaw Belt question

Dustmaker Mike

>I have a 3hp unisaw. It has the standard 3 belts on it. I took the motor off to make it lighter to move it. When I put the motor back on the two outside belts seemed loose. Not by a lot but the center belt is tighter the the outside two. I checked the motor mount and the blade arbor and they seem fine. So is this a problem I should fix before I run it? Should I buy three belts just to be sure? I don't have 220 to it yet to see if works like it is. I wanted to make sure before I turned it on.

Re: Unisaw Belt question

#2

Re: Unisaw Belt question

JerryBurns

>Mike

How much looser are the outside belts. Belt tension should be even on all three belts. as a rule the belts should be able to to move down about 1x the belt thickness. Dumb question did you put the belts back on in the same order as you took them off. I have seen cases were on muilty belt drives where the belts have gotten run in to a particlular pully grove and by relocating the belts they tensionen up just fine

Re: Unisaw Belt question

#3

Re: Unisaw Belt question

Jay St. Peter - SoMD

>Assuming the belts are in the grooves OK a test run will tell the tale. My Unisaw came with a bad set of belts (I assume they took a set). The thing vibrated quite a bit and just looking at the belts you could tell they were the culprit. I got a set from Delta for free, but if I was beyond that period I think I would've gotten some link belts.

Jay

Re: Unisaw Belt question

#4

carl

Re: Unisaw Belt question

Carl

>Sometimes if the saw has been sitting for awhile the belts mold to the shape that they are sitting in and after you run it and they heat up a little then they will be fine.