Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Wood Dye Question follow-up

Posts

Wood Dye Question follow-up

#1

Wood Dye Question follow-up

Rick Snyder

>Hello again,

What type of finish would be preferred after dying the wood. I have used all seversl methods over the years and how long should I wait before applying the finish? Thanks to JL and Clint for their response.

Thanks, Rick

Re: Wood Dye Question follow-up

#2

Re: Wood Dye Question follow-up

Clint Searl, at the base of Haycock Mtn

>The directions on the can of RONAN refined lampblack say that the paste should be thinned with turpentine to be brushed on and top coated when dry. I think a couple days would be enough time for it to dry, but might expect some lifting even then. The alternative would be to mix it directlly into the final finish, whether a drying oil or film finish.

If you use an aniline dye stain, like Transtint, I suggest the water soluble version for its ease of use and color fastness. Mix it with about a quart of water and mop it on the pre-dampened wood. Wipe it back to even out the tone. After it's dry, and rubbed down with a maroon scotchbrite to get rid of the fuzz, it can be top coated with any non-water based product without lifting.

For your application, I think the RONAN approach will give a more even and deeper black than the dye stain which may reveal the grain.

Clint

Re: Wood Dye Question follow-up

#3

JL

Re: Wood Dye Question follow-up

JL

>Alder is going to show some grain after using a dye. What sort of finish are you trying for? Are you trying for a "Japanese lacquer" sort of finish - i.e. a gloss black finish without wood grain showing? A dye would definitely not be in order.

I've typically coated my TranTint dyes with stuff like Tung oil or Waterlox. I usually wait about a day after applying the dye.

Re: Wood Dye Question follow-up

#4

Re: Wood Dye Question follow-up

geary from nj

>Clint, I'm new at this dye finish stuff, so can I ask you back up and slow down a bit? I to am interested in doing a side board in a black finish. From your previous post, I gather,I want to use a dye for a grain look. I really want to try to stay away from an oriental gloss look;thought I'd use a semi gloss lacquer. Is there any thing else I should know?I'm a big chicken when it comes to using something new. Where do you buy your dyes? Haven't seen them in the orange or blue Borgs. Any info will help, Geary from NJ

Re: Wood Dye Question follow-up

#5

JL

Re: Wood Dye Question follow-up *LINK*

JL

>Woodcraft, Highland Hardware, etc.


Highland Hardware

Re: Wood Dye Question follow-up

#6

Thanks JL BIG HELP!

geary from nj

>