Ol' Norm . . .
steve mackay
>WOW ! Watched the canopy bed show last night where he did the laminating / bending / clamping jig thing. Oh, Man, I gotta think up a smaller scale project and give THAT a try ! Suggestions for a simpler starter project ?
Knowledge You Can Build On — Est. 1998
Ol' Norm . . .
steve mackay
>WOW ! Watched the canopy bed show last night where he did the laminating / bending / clamping jig thing. Oh, Man, I gotta think up a smaller scale project and give THAT a try ! Suggestions for a simpler starter project ?
Re: Ol' Norm . . .
Barry Irby
>I did not see the show but I have done a number of bent wood lamination projects.
A simple one was a mailbox post. I removed some treated wood 2 X 4's into about 1/4" by 3 1/2 strips about 3 feet long. Made a form to bend them around a gentle curve to a ninety degree bend. (about a quarter of a circle.) Left the ends straight and slightly long. Cut a half lap joint on the ends and added a straight section of 2x4. Then laminated another full length piece on both sides. So it came out as a 2 X about 3 1/4. It was about six feet tall and three feet long horizontally. So I dug a hole and stuck the long in in the ground. This was a "scraps" project. I had some treated wood left over and some Gorilla glue. Used them both up. Its a very minimalist mail box post.
I would post a picture, but its raining out there.
Re: Shaker boxes?
Glenn Madsen near San Francisco
>I was looking at a not terribly old PopWood this morning, and saw an article on a Shaker oval box music box, by the older fellow who's got a pretty decent reputation in the area. John Wilson, maybe?
That looks like a good place to start with the wood bending part - boxes. The scale is small, the materials approachable, and failures can get chucked into the casual heating systems fuel load easily...