Re: Wood Treatment.... *LINK*
JohnKJordan in East TN
>The Wood Handbook lists longleaf pine as "moderately difficult" to treat by penetration. Are you brushing or soaking? One of my fence books (Fences for Pasture and Garden) indicates that treating fence posts yourself is largely a waste of time and money since the perservative will rarely penetrate completely and the post will rot from the center. They list one possible exception: treating freshly harvested, debarked posts in a solution of borate sulfate (Tim-Bor), claiming that if the moisture content is at least 40% the post will pick up borates from the surface and diffuse them by osmosis to the center. This infusion should be followed by butt-dipping in copper naphthenate, soaking overnight.
Do you have a pressure treatment facility nearby? (I know of two near here) A small operator may be willing to throw your posts in with a batch. The posts should be as dry as possible first.
I'm not familiar with longleaf pine, but if you stand some logs up on end, some water will literally run out the bottom. However, due to the way relatively humidty works, wood dries very slowly in cool or cold weather. Even in the summer, air drying logs is far different than air drying lumber - you didn't indicate the diameter but it may take years for the center to dry.
There are experts available. You might check the knowledge base and/or ask your question on this site:
Wood Web sawing & Drying forum