Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Jatoba sanding and finish

Posts

Jatoba sanding and finish

#1

Jatoba sanding and finish

Doug Reynolds in Seattle

>I am making my first piece of furniture ( small cabinet for a living room) out of Jatoba (Brazilian cherry). Wood seems a little more coarse, like oak, than American black cherry. What would be a good sanding grit to stop at? I would usually stop at 220 and apply an oil for American cherry.

What is your favorite finish recipe for Jatoba? I was planning on applying an oil, no dye or stain, just like I would American cherry. Seems the wood darkens with time anyway.

Re: Jatoba sanding and finish

#2

Re: Jatoba sanding and finish

Howard Acheson

>Be careful using an oil or an oil based finish on jatoba. It's a naturally oily wood and curing and adherence problems are very possible. Some wipe down the wood with acetone or lacquer thinner before finishing. Good finishes for jatoba are shellac and lacquer as they will have no adhesion problems. If you want to use an oil based finish it is best to use a barrier coat of dewaxed shellac. After the shellac, you can use any oil based finish.

I would not recommend an oil or oil/varnish finish.

Re: Jatoba sanding and finish

#3

Re: Jatoba sanding and finish

Jim in Houston

>A couple three years ago I made a dining room table from Jatoba, and to be honest, all I did was finish it with three coats of poly as I knew it would take a beating. Looking at it right now, the finish is fine, and I've yet to spot a ding.

my .02

Jim

Re: Jatoba sanding and finish

#4

Ellis Walentine

It depends on the piece

Ellis Walentine

>If the piece of furniture is going to take abrasion (e.g., a table), I'd consider a hard finish like polyurethane varnish or a sprayed catalyzed lacquer. If not, then a Waterlox finish would be lovely.

Ellis Walentine, Host

Re: Jatoba sanding and finish

#5

Follow-up to Ellis

Doug Reynolds in Seattle

>The piece is a small liquor cabinet for a co-worker's vacation condo in the snow-covered mountains of Leavenworth, Washington. Since the condo is small, the piece is only about 16 X 16 X 38. It will, however, also function as a wet bar.

I can take the piece to a professional finish shop for CAB lacquer which is what I did for my daughter's bathroom vanity or, do Waterlox at home. What is best or since this is such a small piece for occassional use, does it mater?

Re: Jatoba sanding and finish

#6

Re: Jatoba sanding and finish

Jim Dillon

>Doug,

I've had luck sanding Jatoba to 220 grit and then using an oil/varnish mix (Tried and True). Yes, it does darken the wood a bit, but seems to work just fine. If I don't want the T&T to darken the wood as much, I apply a single coat of blond shellac (1# cut) and lightly sand with a gray abrasive pad, then apply the T&T with a white nonabrasive pad. T&T has a rep for drying slowly, but I've almost never had any trouble except with a plywood panel of red oak where it did indeed take days and days and ... . If you're interested in more of my experience using jatoba to build a large piece of furniture, check out Shop Shot #762. The wood is actually more red-brown than the pics in that Shop Shot show. Hope this helps.

Jim