Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Removing Twist from Finished Walnut Board

Posts

Removing Twist from Finished Walnut Board

#1

Removing Twist from Finished Walnut Board

Brad Bellm

>I am refinishing a secretary's desk that my grandparents used in their home for years and years.

It is solid walnut with a fold down front.

The front piece of the fold down front is 3/4" X 4" X 30" and when placed flat on my table saw is twisted approximately 1/2" (one corner is up 1/2").

Does anybody have any ideas of how to get the twist out without machining or building a steam box?

Re: Removing Twist from Finished Walnut Board

#2

Re: Removing Twist from Finished Walnut Board

Bill White

>I know you don't want to hear this, but.....

Leave it alone. That puppy is old, and is best preserved as es. It is just showing some of the quirks that old furniture will evidence. We have some old antiques that have all those "character" marks. They will stay just the way they are.

Bill

Re: Removing Twist from Finished Walnut Board

#3

Re: Removing Twist from Finished Walnut Board

Greg Haugen

>Added Character! I agree. I was watching a show on refinishing and this statement (or something along these lines) was said a lot. "A good refinish job shouldn't show that it's been refinished. An antique should be just that, not turned into a "new piece" with old boards. Repair for structural integrity but leave the "personality" of the piece alone."

Another point is since the board is twisting already trying to work it, etc. will most likely "release" more of the stresses and it could become worse. It's stabilized now, not flat but stable.

Hope that helps.

Greg H.

Re: Removing Twist from Finished Walnut Board

#4

Re: Removing Twist from Finished Walnut Board

George@Colonel's Workshop-Havertown, PA

>Good Afternoon Brad,

There are a couple questions. Was the desk lid warped before you began refinishing it? If it warped during the stripping, were both sides stripped? Had the desk hinges ever been adjusted to partially compensate for the warpage? Have you put the desk lid back on the desk carcase to see how much of a visual problem you have? Does the lid bind as it is opened and closed?

If the lid was stripped, it could well be that one side contains more moisture than the other, causing it to warp. Wait a while and let it reach equilibrium.

I had something like that happen to a client's piece. Fortunately it involved only a portion of the lid, and I was able to make a replacement for the defective boards, glue them up and match the color and shade of the surviving lid part.

George

George