Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Bandsaw Question

Posts

Bandsaw Question

#1

Bandsaw Question

Larry Gottlieb

>I recently replaced the tension assembly of my 14" jet bandsaw. The tracking arm had bent so that it hung up on the upper wheel guard cutout hole.

What is the cause of this part bending? Should I loosen the tracking knob after each use?

Thank you for your help.

Larry

http://webpages.charter.net/lgottlieb2/

Re: Bandsaw Question

#2

Re: Bandsaw Question

JohnKJordan in East TN

>Larry,

Evidently this is common and a possible design weakness. From Iturra Design's bandsaw accessory publication:

"If your Delta 14" band saw has any age on it, you will begin to notice that when you track a blade the tracking arm will begin to hang up on the upper wheel guard cutout hole. What has happened in many cases is that the tracking arm has begun to bend..."

They go on to show pictures and describe the problems this can create. They do offer a stronger replacement and other upgrade parts for the Delta. I bought some of them for my saw and have been happy with both the parts and the service.

Their catalog, BTW, is more like a book with 200+ pages of bandsaw information and tips in addition to their products and various tools. They'll send one out to you if you call or email, 866-883-8084, KRALLL@comcast.net

JKJ (no connection to Iturra)

Re: Bandsaw Question

#3

Re: Bandsaw Question

Larry Gottlieb

>Thanks John.

I spoke to Louis Iturra about this and he told me that the tracking arm on the Delta could be replaced, but the Jet design required that the entire tension assembly be installed. I did this.

My question is what can I do to prevent the arm from bending again.

I suspect that releasing the tension on the arm will help and the only downside is that each time I use the saw I will have to adjust the tracking and the blocks and thrust bearings.

I have the time, being retired.

Larry

http://webpages.charter.net/lgottlieb2/

Re: Bandsaw Question

#4

Re: Bandsaw Question

JohnKJordan in East TN

>Don't you love retirement!

Sorry, my mind put "Delta" where you wrote "Jet"!

Why do you have to readjust the tracking after retensioning? I added a quick-release tensioner to my Delta and the tracking and alignment always seems to return properly. There was much difference of opinion about releasing the tension the last time this was discussed on the forum, but I am a firm "release" advocate.

Also, proper tensioning was always a wild guess for me so I bought a tension meter from the Iturra guys. It seems that assurance that the saw is not overtensioned would be a step towards preventing it from bending again.

JKJ

Re: Bandsaw Question

#5

Re: Bandsaw Question

Larry Gottlieb

>John,

I would have to readjust the tracking only if I loosened it to prevent the arm from bending.I don't know if loosening it helps.

When I released the tension only I didn't have to readjust the tracking.

I set the tension at the scale on the sliding bracket and I would guess that it is lower than Iturra recommends.

It looks like my hobby is keeping the bandsaw tuned with a few minutes left for turning.

Lerry

http://webpages.charter.net/lgottlieb2/