Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Spray Finishing

Posts

Spray Finishing

#1

Spray Finishing

Paul T

>Hi All,

I'm looking to buy a spray gun for lacquer for a gift but don't have a clue as to what specs to look for. Any thoughts? What do you prefer?

TIA,

Paul

Re: Spray Finishing

#2

Re: Spray Finishing

Greg Haugen

>Do you know if they use a "conventional" system or a HVLP (High Volume Low Pressure)system? That would help to narrow the options.

There are alot of good things to say about Gleempaint.com

Greg

Re: Spray Finishing

#3

Spray Finishing

Paul T

>Rookie Finisher with a conventional system.

Re: Spray Finishing

#4

Bart Goldberg

Re: Spray Finishing

Bart Goldberg

>First question - do you have an air compressor, and if so, how big?

Re: Spray Finishing

#5

Re: Spray Finishing

Paul T

>Yes, 15 gallon porter cable, I don't remember the horsepower rating.

Re: Spray Finishing

#6

Re: Spray Finishing

Mac in Indy

>Get a hold of Jeff Jewitt at homesteadfinishing.com

He has a wide aray of products and can help you figure out what is best for you.

Mac

Re: Spray Finishing

#7

Re: Spray Finishing *LINK*

Mark Mandell - Gone Round In Jersey

>Paul,

The suggestion to contact Jeff Jewitt is a good one. I'm linking this to Jeff's site where you can browse guns that cover a wide range of prices. You can also read and post on several of Jeff's finishing forums to get feedback from him and other finishers (pro's and am's) there, as well as call him directly (during the week) for recommendations and advice on equipment, methods, and materials.

mm


Homestead Finishing Main

Re: Spray Finishing

#8

What size compressor is needed?

Mark in Whitby

>I have a small pancake compr. and have heard varying accounts of its suitability for HVLP spray finishing. Other then the small tank and therefore the need to re fill more often are there any other impacts or obstacles?

thnx

Mark

Re: Spray Finishing

#9

Re: What size compressor is needed?

NickB

>Bigger is better, but it depends on the size of the gun. I've got a "3 HP", 12 gallon oilless that I use with a small HVLP gun (STM). The compressor runs a fair amount, but not all the time.

I second (or third) the suggestion to go to Jeff Jewitt's website. There is a general BB there where you can read up on previous suggestions, then post your exact situation to get a suggestion on a system.

OTOH, if you are spraying thin bodied clears like shellac and lacquer, I've heard good things about the Critter sprayer (but I don't know that it can atomize heavier finishes).

Hope this helps,

Nick