Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Denis Chenard where are you?

Posts

Denis Chenard where are you?

#1

Denis Chenard where are you?

Art Silva

>I thought you would answer my inquiry as to what routers you have by now, and since I will be busy for a few days, here goes.

If you have a Porter-Cable, Hitachi M12V, DeWalt 625, Elu 12",DeWalt 621, DeWalt 616/618 series, a Craftsman/Bosch, or Fein, Festool or Freud their is an Eliminator Chuck for you. No need to buy a bunch of costly inserts, when one{1} approx. $70. chuck will suffice. It takes 1/2" shanks, and readily accepts 3/8, 5/16{8mm), and 1/4" adaptor sleeves. A quick twist with a 5/32" t-handle allen wrench and you are in business.

The #1 chuck is for P-C, #2 is for 616/618 series DeWalt @ Hitachi M12v, #3 fits DeWalt 625 & Elu 1/2",Freud, Fein & Festool, #4 fits Craftsman/Bosch. The DeWalt 621 fits in there somewhere but I forget the number. Basically, for about 75 to 80 bucks US, your problem is solved.

Re: Denis Chenard where are you?

#2

The DW621, takes 616/618 chuck.

Art Silva

>Eagle America sells a chuck called the xtreme xtension #415-0650. It can only be used in a table with a plunge router with variable speed.

The Eliminator chuck does not have this restriction, although larger diameter bits should be slowed down. They also sell the Eliminators

Re: Denis Chenard where are you?

#3

Right here!

Denis Ch�nard, Orl�ans, Ont.

>Sorry, was busy last night and today...

I don't have any of the routers you listed, I think. I have:

- Craftsman plunge router, 15 amp, VS, SS (used to be their top of the line offering)

- Same machine (at least visually), but 12 amp and no VS or SS. Collet is different too (sleeves instead of inserts)

- HausMann (Canadian Borg house brand) plunge router, 10 amp, VS but no SS, 1/2 and 1/4" collets.

- Canadian Tire Mastercraft (house brand) VS plunge router (no SS), 1/4" collet

- Triton 2 1/4 HP plunge router

- Ridgid laminate trimmer

I'd like ideally to keep the Triton, Ridgid (which will not be mounted in a table) and top Craftsman flexible, and set up the other three with one bit.

The eliminator chuck looks like a good idea, but I seem to remember reviews which said that either the chuck added to runout, or that the grip on the bits was sub-optimal. What's your experience?

Thanks for the info,

DC

Re: Denis Chenard where are you?

#4

I am convinced that those who complained

Art Silva

>about run-out on an Eliminator chuck did not follow the directions, which specifically state how to find the "sweet spot" when installing the chuck. I have four of these installed without problems.

Unless your Craftsman is a Bosch clone, it will not accept the Eliminator.

The Triton is a great router for hand-held or table, with a great feature for above the table bit change, but I don't think it will mate with the chuck. Good luck.