Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

warped wood------WebKitFormBoundaryvG+Z4Lo7QpgTMJ+

Posts

warped wood------WebKitFormBoundaryvG+Z4Lo7QpgTMJ+

#1

warped wood------WebKitFormBoundaryvG+Z4Lo7QpgTMJ+

Bob Ho------WebKitFormBoundaryvG+Z4Lo7QpgTMJ+K

>Short version:

I resawed some curly big leaf maple and it sproinged open like a clamshell, becoming pretty badly bowed. The boards are roughly 7/8" thick and I was hoping to be able to get 3/4" once planed but will be lucky to get 1/2" final thickness, probably a bit on the thin side for a dining table top. I am thinking of trying to wet the concave surfaces and pile a bunch of weight on to try and flatten them a bit. Anybody had any luck flattening bowed boards this way?

Long version:

Awhile back I bought some rough 2" x 9 1/2 -11" x 8' planks of big leaf maple with the intention of resawing them and making a dining table. I cut them in half and built a sled so that I could use my planer as a pseudo jointer.

To my dismay there were quite a number of checks below the surface, visible once I had planed the boards down. I was pretty disappointed but they have been sitting in my shop (flat with sticks in between) for about 2 years now and I am over the initial disappointment. It's beautiful wood and a few "stretch marks" isn't going to ruin it for me.

Anyhow as mentioned above I guess there were major internal stresses which were released upon sawing them open. I guess the lesson in a case like this is to resaw right away and then sticker, especially with such (in retrospect) obvious signs of improper drying and internal stress.

In case you haven't guessed I am kind of a beginner taking on an ambitious project.

Thanks for any input!

Bob

------WebKitFormBoundaryvG+Z4Lo7QpgTMJ+K

Re: warped wood------WebKitFormBoundaryvG+Z4Lo7QpgTMJ+

#2

Re: warped wood *LINK*

JohnKJordan in East TN

>I straighten outdoor wood (barn siding, etc) like that all the time - just set it on the ground with the convex side up, concave side down, and let the sun dry the top and the ground moisten the bottom. The boards usually straighten up quickly. SO, that method might work, however...

I'd be hesitant to try that with dry wood intended for furniture. Seems like it would bump the MC way up. Perhaps if you stickered and re-dried? (No experience here.)

I'm sure you will get voices of experience from others here. You might also try asking this and/or searching the knowledgebase on the Wood Web sawing and drying forum. Dr Wengart and others there have a great deal of expertise in that area.


sawing and drying forum