Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Semi-OT - hardboard as counter top?

Posts

Semi-OT - hardboard as counter top?

#1

Semi-OT - hardboard as counter top?

John E

>I'm helping a buddy make some counter tops for cabinets in his garage. Since laminate is $45 a sheet, I remembered seeing some posts about people making sacrificial workbench tops out of hardboard. I was thinking about using 3/4" MDF, topped with a 1/8 or 1/4" piece of hardboard for the counter top. My concern is, my friend's a gearhead/grease monkey, not a dustmaker like us. Would hardboard hold up to gas / grease / solvents? Would painting it help, or just make a bigger mess?

Thanks,

John

Re: Semi-OT - hardboard as counter top?

#2

Lee Grindinger

Cheaper yet

Lee Grindinger

>Use 3/4" particle board. Finish it with a grease resistant film like poly or enamel paint. I used unfinished particle board as bench tops for years.

Lee

Re: Semi-OT - hardboard as counter top?

#3

JL

Re: Semi-OT - hardboard as counter top?

JL

>I used sheets of 1/4" tempered hardboard for my counter tops. I used 3/4" poplar plywood as the base and edged it with oak (~ 3/4" thick x 1 1/4") so that the oak holds it on the base cabinet and also "grips" the hardboard.

I then wiped it with several coats of diluted gloss polyurethane. It has held up against glue and the occasional finish and mineral spirits spill. It is only hardboard, so I figure I can replace it easily enough. It has worked quite nicely.

Another alternative is to go ahead and get shower board from the BORG. I used some leftover shower board from another project for the top of my sharpening cabinet. The shower board can be wiped down easily.


img

Re: Semi-OT - hardboard as counter top?

#4

JL

Re: Semi-OT - Hardboard pic 

JL

>


img

Re: Semi-OT - hardboard as counter top?

#5

Re: Semi-OT - hardboard as counter top?

George (Oxford, NC)

>I have no idea what it costs, but have you priced sheets of steel about .030 thick? I have friends that are automobile freaks and they have their benches covered in steel sheeting.

George