Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Who makes that router bit

Posts

Who makes that router bit

#1

Who makes that router bit

Dominic Greco in Richboro PA

>that cuts the "v groove" in the edge of plywood so that you can apply a mating triangle shaped (when viewed edge wise) hardwood edging? I seem to remember seeing it featured in an article in FWW. But so far I can't find it.

I think it's a set. One for cutting the plywood, and one for cutting the edge banding.

If anyone has experience using this, I'd love to hear about that as well.

Thanks in advance,

Dominic

Re: Who makes that router bit

#3

Re: Who makes that router bit

Ken Oakley-Sunny St. Cloud, Fla

>Eagle America has a set. In fact it is shown on the cover of their latest catalog. They do have an online catalog-Eagleamerica,com

Re: Who makes that router bit

#4

Re: Who makes that router bit *LINK*

Ron Hildreth

>Dominic,

Try MLCS. I thought about buying the set, myself, but opted for a spline, since I already had the bit.

Ron in Iowa


MLCS Router bits

Re: Who makes that router bit

#5

Re: Who makes that router bit *LINK*

Bob Lemon Sacramento Ca.

>Dominic, the V cutting bit will not give a straight line if your plywood varies in thickness or cannot be held down tight to the table. I use and recommend the plywood tongue and groove set. The set I'm using is an Amana set that I've had for years. Here is a link to Infinity's set.


http://www.infinitytools.com/products.asp?dept=1302

Re: Who makes that router bit

#6

Re: Who makes that router bit

john b. southwest Chicago burbs

>I use the tablesaw to cut the 'V' groove, that way i know that the groove is centered. I then cut a square piece of stock, fit it in the groove clamp and glue. Trim square stock after glue dries. If i am making more than one shelf i sandwich the square stock between two shelfs. Trim square stock and part the shelfs. Quick and easy. john b.

Re: Who makes that router bit

#7

Thanks everyone

Dominic Greco in Richboro PA

>Thanks for the pointers. I appreciate the help.

As luck would have it, shortly after typing this question I came up with way to use standard hardwood edging. :>)

Thanks again!

Dominic