Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Sagging TS wing

Posts

Sagging TS wing

#1

Sagging TS wing

Edward in Vancouver

>Was cleaning up my TS the other day and noticed the left wing is sagging a bit in the middle. I bought the TS new about a year ago, a Delta contractor jobbie but with cast iron wings and a fairly decent fence system.

By laying a straight edge along the length of the wing, just near the joint where it meets the TS, I could jam a .003 feeler gauage in the gap, moving he straight edge to the extreme left of the same wing, the gap was around .0025. The central part of the TS was pretty good, couldn't get a feeler guage in there, but a litle light did shine through when a flashlight was placed behind the straight edge, and the right wing a little saggy, a.001.guage could just make it under the straight edge.

Other than irritating me, will the sag on the left wing make any difference? More importantly, will it get any worse? I torqued up the bolts mounting it to the TS as tight as I could get when I installed the wing a year ago and rechecked them, still very tight.

Re: Sagging TS wing

#2

Re: Sagging TS wing

Bill Howatt

>I think your measurements are interesting although of no concern when working with wood. The flatness of the basic table with the miter slot is of more importance and I wouldn't get upset if that part of the saw had your measurements. Your .0035" is less than 1/256". If I spent big $$$ for an expensive cabinet saw I might expect better.

Of more concern to me would be the flatness from the blade to the extreme left of the wing. It should be as flat as possible so the stock is supported on the same plane as the basic table by the wing. This can be adjusted with thin shims where the wing bolts onto the saw.

Bill

Re: Sagging TS wing

#3

Quick way to fix TS wing sag.......

Thomas Skaggs, Foothills of Mount Level

>....one word....Botox. ;-)

Tom

Re: Sagging TS wing

#4

Good advice

Clint Searl, at the base of Haycock Mtn

>

Re: Sagging TS wing

#5

Re: Sagging TS wing

Larry Clinton At Frankfort (Central)., Indiana

>Edward, I would not be a bit concerned if my Unisaw had tables out of flat by .0035". The wood you are sawing will probably move much more than that during the sawing operation. The tolerance you are describing is more in line with PRECISION metal working machines. You are literally splitting hairs.

Re: Sagging TS wing

#6

Re: Sagging TS wing

Edward in Vancouver

>O.K., thanks gentlemen, was kinda sure I was making a big deal out of things. Granted the Delta is not a precision instrument, but the more I work with it, the more I understand it and like using it.

My only really big beef with the saw is with the splitter, but I think this a combintion result of low pricing and a fear of lawyers/lawsuits....

Re: Sagging TS wing

#7

Splitter

Thomas Skaggs, Foothills of Mount Level

>You might consider buying a Beisemeier splitter as a replacement. It's a tad pricey but worth it IMO. It snaps in and out easily and is well made. It have it on my Uni and I'm a satisfied customer.

Tom

Re: Sagging TS wing

#8

Edward - you're right

Howard In Toronto

>The stock splitter is a pain.

I never used mine until one day as I was cutting some plywood, the gap started closing past the blade and the plywood started trying to blow itself back at me.

Scared the fertilizer out me and I bought the $30 Delta-brand splitter to keep the kerf open.

Night and day difference.

HTH

Howard