Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Puzzle kerf

Posts

Puzzle kerf

#1

Puzzle kerf

Wayne Allison

>I am making about sixty pre-school interlocking wood puzzles as Christmas presents. Older children will be painting them as presents for needy children. They are very simple: Made from white wood one-by-six stock. Only three or four pieces. Non-toxic paints. The problem is I need to keep the kerf thin so the puzzles won't be too loose without complicating the assembly by the pre-schoolers. It seems that the pieces will only connect from one direction. This is caused by the scroll saw blade moving (slanting) when I make a tight turn. Got any suggestions?

Re: Puzzle kerf

#2

Re: Puzzle kerf

Bill White

>Make sure that the tension on the blade is correct. Second, take your time on the curves. Push it and the blade will flex (more in 3/4" stock). Too fine a tooth will make you want to force the cut.

Bill

Re: Puzzle kerf

#3

Re: Puzzle kerf

NickB

>With thick stock on the scroll saw, I've found you need to be very careful with your technique-the stock must always be pushed *into* the blade (for curves, the point where the blade and workpiece meet must be the pivot point-it's pretty easy to start pushing the workpiece sideways, and the blade will deflect then).

Hope this helps,

Nick

Re: Puzzle kerf

#4

Re: Puzzle kerf

Ron Hildreth

>Wayne,

Tighten up your scroll saw blade. You should be able to pluck it with your finger and it should sing a high note. Don't be afraid of breaking it, as this is what gives the blade it's strength and prevents it twisting or bending while in use. Another thing to check is the size of blade being used. If your wood stock is 3/4" or less hardwood, and your cuts are going to make sharp turns, try using a 2/0 reverse tooth blade, or even a spiral blade (#2) if your cuts are not going to be straight. Straight cuts with a spiral blade is nearly impossible. Make sure that while making a turn, you're also feeding the work piece into the blade. If you stop feeding the wood and think you're going to just turn it, you will break the blade. If that doesn't work for you, try making relief cuts into the scrap portion of the work piece. Practice on some scrap to find what works best. Good luck!

Hope this helps!

Ron n Iowa