Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Regardaing the broken Universal clamps:

Posts

Regardaing the broken Universal clamps:

#1

Regardaing the broken Universal clamps:

Carol - now in NC Nebraska

>For some reason a normal reply to your post isn't possible. I suspect the guru's are working on it. So meantime....my response.

Wow! I've used those clamps for years and I have never broken one. And I weight more than you do. Never mind how much more. :)

It is not necessary to clamp them that tight. You are squeezing all the glue out of the joint. If you have gaps that you are trying to close, then your joinery needs more practice.

I close the clamp until I have a firm connection and then add a quarter turn more. That is enough.

Or at least it always has been. :)

Incidentally, these clamps are used by cabinet shops all over, because they are lightweight and strong enough. If they had an inherent flaw, it would long ago have been addressed.

Re: Regardaing the broken Universal clamps:

#2

Right on, Carol

George@Colonel's Workshop-Havertown PA

>I tried twice to say that in failed posts, and the new email system didn't work either. I have been "Universal"ly disappointed. It sounded to me that Karen was using too much enthusiasm by cranking the clamps with both hands. While those aluminum clamps are not as robust as my Ponys and Jorgensens, they should be fully capable.

George

Re: Regardaing the broken Universal clamps:

#3

The Story on Universal clamps

Bill Tindall, E.TN

>These clamps used to be made by a friendly family business in CA. They used only the best metal in the clamps. They sold clamps to furniture factories where they were tightened with air wrenches. They are inherently strong. The failure mode for extreme tightening is the female thread will deform and make the threads not as smoothly working (now how do I know that....). Our club has ordered hundreds of these clamps (half price when ordered direct) and I am not aware of any failure.

A couple of years ago the family business sold out to a larger manufacturer. They were having a hard time finding a casting company to cast the aluminum parts. It may be that the new company is having casting issues.

Let us know how this problem gets resolved.