Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Norm's Plans *LINK*

Posts

Norm's Plans *LINK*

#1

Norm's Plans *LINK*

Bill In Sacramento

>Hi All,

I would to take a try building a piece or two of furniture. I decided to check out the local library, pick out a how to book and give it a go.

I found a book, The New Yankee Workshop by Norm, Page 64 begins the how to sequence for a very nice Bedside Table. About half way through gathering the stock and beginning the layout I noticed a few serious omissions in the plans/drawings and narrative.

The length of the rails is missing. The width is stated but the lengths are not there, Also, the dimensions between the front rails that determine the drawer opening size are missing as well. I have a feeling that the same problems will surface when I get to the section about building the drawer.

Could any one who built this table provide the missing dimensions Or point me to a plan that includes all of the important info?

Regards,

Bill


Cover Of Norm's Book

Re: Norm's Plans *LINK*

#2

Re: Norm's Plans

Mark McC

>Hi BIll

I have that book and I think the idea here is to give you some of the basic dimensions and construction methods but allow (force) you to determine and work into the basic plans your own rail dimensions.

This may or may not be intentional, but no matter, its pretty easy to figure out and there is no WRONG dimension meaning you can get close and no one will know the difference.

If I had to guess judging from the picture and knowiung the table top final dimensions with BB ends, it looks like the top has at least a 1" overhang all the way around.

Using that you can figure out what the rails need to be with tenons and including thickness of the legs to determine your rail dimensions...thats the fun part figuring it out!

1" overhang 1 1/2 inch over hang 3/4 over hang...its your baby and you cant go wrong.

Good luck with the project

Mark

Re: Norm's Plans *LINK*

#3

Re: Norm's Plans *LINK*

Bill Kay

>Hi Mark,

Thanks for the response. I guess I'll have to wing it and see if it turns out OK. I'm much better at designing and finishing projects on the lathe.

At least at this time of year I'll have a use for firewood.

The problem I have is the Ad for the book doesn't, in my opinion, match the reality of the incomplete or missing info. Here is a quote from the ad for the book at New Yankee ... "dozens of detailed drawings" and "This volume takes you step-by-step". Some of the steps are missing and detail drawings are lacking some vital info..


Ad At New Yankee

Re: Norm's Plans *LINK*

#4

Re: Norm's Plans

Bill Murphy/Reading,PA.

>If you look on page 67 you'll see that the legs are 1-9/16" thick. Times that by two and you have 2-1/4". Subtract that from the length and width of the base, (12-1/2" x 16") and you'll get 10-1/4" side rails and 13-3/4" front rails plus the length of your tenons. You should double check my math as I did this on the fly.

Also, I built that table as my first project and glued the breadboard ends completely to the top as I think was instructed. The top split from not being able to expand and contract. So you'll have to use the proper technique for breadboard ends.

Good luck.

Bill