Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Strange air leak question?

Posts

Strange air leak question?

#1

Strange air leak question?

Barry Irby

>I move my DC and Air Compressor out into an Exterior closet in back of my shop a year or two ago. I leave the Compressor "on" all the time so that I have Compressed air available. The timing is a little vague here so bear with me. After a while I noticed the compressor would run occasionally even if I were not in the shop. I checked for leaks and found none in the hoses and fittings. (Just a fifty foot hose run in through a hole in the wall.) I started to turn the compressor circuit off when I left the shop. Later I fell out of the habit and noticed the problem had gone away. So, now the mystery leak has reappeared. I realized I was reluctant to go outside and search for the leak because it is cold out there. Then I wondered if it was the cold causing the leak? Is that why it came and went? Is there something about a compressor that would leak in cold weather and not in warm?

I fear the leak will get much worse and I will come home to a burnt up compressor or worse a burnt up house. Not to mention the waste of electricity.

Re: Strange air leak question?

#2

Re: Strange air leak question?

Gary Evans Tallassee, TN

>Hi Barry,

Get out your squirt bottle of soapy water and spray every connection in the system, including the one at the end of the hose where you plug your tools in. Don't forget the tubing connections on the compressor, the tank, the pressure switch, etc. Also don't forget the drain fitting on the bottom of the tank. If your compressor and hose are more than three or four years old, spray down the tank and the hose as well. If you don't strike bubbles somewhere I'll be surprised. Also, if I remember correctly, a little soap works better than a lot in your mixture. You might experiment with that.

If you are still flummoxed after all that, you can always wire up a relay that would operate from the light switch to shut off the power to your compressor whenever you leave your shop.

Gary

Re: Strange air leak question?

#3

Re: Strange air leak question?

Patrick Jaromin

>My van has an automatic tire pressure sensor to report flats. I've noticed that every Fall, when it first turns cold out, the van computer will report a flat. The tire's not flat per-se -- but the pressure has fallen below the system's threshold.

I'm sure my explanation is scientifically correct, but essentially colder air takes up less space than warmer -- ie. less pressure. My guess is that the pressure in the tank is going below the threshold as the temperature goes down.

Re: Strange air leak question?

#4

Re: Strange air leak question?

Barry Irby

>3 or 4 Years old, try 36 years old. Its a Sears compressor I bought right after college. I actually bought a used replacement for it and it was broken when I got it, so the old one went back into service. I guess it's time to give it the once over, but its cold out there and it in the bottom of the closet and I will have to stand on my head to see it. Has anyone else noticed that your tools own you? Of course, this one is geriatric and it may be time for it to retire.

Re: Strange air leak question?

#5

Hmmm? I wonder?

Barry Irby

>I ever notice it running when I am in the shop except when I use air. What happens is I leave the shop and eventually end up in my bedroom which is above the shop and then I hear it run. I wonder if because it is getting colder at night it runs because the pressure falls? Or is it just that things are quieter and I can hear it better from my room?

Re: Strange air leak question?

#6

36 years old???

Denis Ch�nard, Orl�ans, Ont.

>More than time to retire that machine... You don't know what shape the tank is, and you probably don't want to know... I believe that in industrial setups tanks are supposed to be tested after five years and replaced by 10, I hope someone more knowledgeable than me can chime in on this.

Variations in temperature shouldn't be enough to trigger the compressor (unless at the very threshold, and that shouldn't happen very often). You have a leak somewhere, one possible (among many) culprits is the quick release connectors, some have a tendency to leak. But at that age it could be anything, valve train, corroded fittings, etc.

But you should really, really, really replace that compressor... Do you drain the water from the tank regularly?...

DC

Re: Strange air leak question?

#7

Jason Roehl in Lafayette, IN

Perhaps...

Jason Roehl in Lafayette, IN

>...there is a marginal connection somewhere that, when cold, begins to leak slowly, causing the compressor to cycle.

I agree with the 36-year-old assessment, though. That's getting to the age where long-term metal fatigue can cause a sudden, catastrophic failure. A pinhole caused by rust in a decade-old tank is one thing--that will just leak out. A 4-decade old weld could fail suddenly giving you a not-so-fun demonstration in how little a house slows down an exploding air tank (happened once to a friend of a friend, left a neat hole in the ceiling and roof of the garage).

Jason

Re: Strange air leak question?

#8

Re: Old Sears Compressor

Kneale Brownson awaiting snow in N. MI

>My Sears compressor of the same vintage developed a pinhole leak in the bottom of the tank this summer that I discovered just as I was starting a roofing job on a rental. I plugged it with a sheetmetal screw and faucet washer and got the job done, but decided to replace the tank. I found an 11-gallon portable air tank on FleaBay to replace the original 12-gallon version and cut off the wheels, foot and compressor/motor mounting plate so I could attach them to the new tank. A $20 fix. The compressor itself and the motor worked fine and I could see no reason to discard them in favor of spending $2-300 on a replacement setup. BTW, I always drained that tank between uses but it rusted through anyway.

Re: Strange air leak question?

#9

Dale Lenz

Re: My 1978 Sears does that...

Dale Lenz

>sometimes. Notice the air coupling at the end of the hose sometimes leak, oh so slowly, depending on which way the air nozzle lays when I toss it down. Have purchase a new coupler, but it's one of those things, when it get worst or I think about it and have the time, I'll change it. I unplug my compressor, usually, when I through for the day. Soap and water test all the joints.

Re: Strange air leak question?

#10

Re: Strange air leak question?

anonymous

>make sure you don't leave leaky tools plugged into the end of your air hose when you leave at night.

Re: Strange air leak question?

#11

Thanks Guys.......

Barry Irby

>I have done the easy things. I stuck the shop end of the air hose into a bucket of water complete with the nozzle. No leaks. I did not stick my nail guns in the bucket, but it is usually the nozzle that lives on the end of the hose. I tried it with and without the nozzle. If there were any bubbles coming off it, you would need a calendar to time it. Guess its time to do the soap bubbles on the compressor out in the shed. I get to go stand on my head. Thanks again.

Re: Strange air leak question?

#12

Re: Thanks Guys.......

Bill White

>I bought my Sears compressor in 1978. Hmmmmm. That's 29 years ago. I unplug before leaving the shop each night.

Bill