Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Sanding short pieces on Performax Question?

Posts

Sanding short pieces on Performax Question?

#1

Sanding short pieces on Performax Question?

Barry Irby

>I have a Performax 16/32 and want to sand a bunch of little square "pickets". They are about 5/8" square and 5" long. Not long enough to reach both feed rollers. Do I need to make a sled or carrier carrier?

Re: Sanding short pieces on Performax Question?

#2

A.J. Hamler

Three ways to do it

A.J. Hamler

>Barry...

Yep, pretty much like planing small pieces, you can do one of three things:

1) make a sled for them

2) temporarily attach longer "runners" on the sides. These can be hot-glued or even regular-glued, and then cut off later

3) You can also feed them through in tandem, with the trailing end of the previous piece butted up firmly to the leading end of the next piece. That way the rollers will always have something under them; the sander can't tell the difference between a long board and several short ones butted up against each other.

A.J.

Re: Sanding short pieces on Performax Question?

#3

Re: Sanding short pieces on Performax Question?

Ron Hildreth

>Barry,

I have the 22-44 PerformaX, and I've sanded pieces shorter than that with no problem, even though they say not to. Did a good job, too!

Ron in Iowa

Re: Sanding short pieces on Performax Question?

#4

Re: Sanding short pieces on Performax Question?

Ron Hildreth

>Just read what A.J. suggests - butting them one behind the last one, and that's how I did it. Took A.J. to jog my memory!

Ron in Iowa

Re: Sanding short pieces on Performax Question?

#5

A.J. Hamler

That's probably...

A.J. Hamler

>...the most jogging I've done in a while, too!

A.J.